Hi all. Looking for some guidance. I just replaced my shifter cable purchased from Kirbans. The cable I took out looked slightly shorter. I was concerned but I put the new cable in anyway. I went through all the gears and back to park but it won’t go to park on the selector. Same thing when it’s in low. I shift to second and the selector doesn’t shift. The selector doesn’t shift into second until the shifter is in the drive position. On my selector on the tranni it is slotted. Looking at pictures on this forum and also googled “Grand National tranni linkage” the selector is not slotted. Am I correct saying the selector is wrong on my tranni? If i’m wrong what am I missing? Any and all feedback would be greatly appreciated. Thanks!