Rear sway bar pics by manufacture

[CGASTON]

I know that there are several of manufactures out there that produce a rear sway bar. I would like to get a list together and pics of each. Can I get some help on this?

 

[kels87gn]

Me too post some pictures. Mines stock.

 

[scot w.]

DSE Rear sway bar - $325.00 available in 1-1/8" or 1-1/4"

 

[CGASTON]

DSE Rear sway bar - $325.00 available in 1-1/8" or 1-1/4"

View attachment 216991

Thanks Scott

 

[noahzark]

Don't most go with the hr rear sway bar? Is that one just known to be the best?

Sent from my SGH-I317M using Tapatalk

 

[NEVER ENOUGH]

Detroit speed set up installed

 

[Royal-T-Ltd]

here's an installed pic of the H&R Bar

 

[NEVER ENOUGH]

Detroit Speed bar, closer comparison pic to Royal-T-Ltd's

 

[deathraider6996]

Geez talk about attention to detail^^^ nice job

Sent from my EVO using Tapatalk

 

[Jims project]

Detroit Speed bar, closer comparison pic to Royal-T-Ltd's

View attachment 219494

What is the part number for this bar? did you get it through Summitt? Very nice looking undercarrage

 

[NEVER ENOUGH]

Mine came from the guy that posted here ^ post #3. It was awhile ago, so I don't recall part number off hand. I'd have to do some diggin'. I'm sure Scot could help. I believe mine is 1 1/8" though

 

[scot w.]

Summit don't do nothing to help keep TB.com here and alive, Help all of us supporting vendors here who do....

DSE bar that fits the GN axle tubes is as follows:

1-1/8th Bar # 42213 = $325.00
1" Bar # 42212 = $325.00

 

[Jims project]

Summit don't do nothing to help keep TB.com here and alive, Help all of us supporting vendors here who do....

DSE bar that fits the GN axle tubes is as follows:

1-1/8th Bar # 42213 = $325.00
1" Bar # 42212 = $325.00

haven't seen this bar before, was wondering where it came from, and I do buy 95% from venders

 

[scot w.]

haven't seen this bar before, was wondering where it came from, and I do buy 95% from venders

Good Deal, Thanks for supporting us! If we can help you with anything just let us know....

 

[kels87gn]

What's the difference in the 1 1/8 and the 1" bars. Will I notice a difference? It's just a street driven car. No track time. Also is the DSE bolt on or do you have to do any drilling/cutting?

 

[scot w.]

What's the difference in the 1 1/8 and the 1" bars. Will I notice a difference? It's just a street driven car. No track time. Also is the DSE bolt on or do you have to do any drilling/cutting?

Each DSE bar has rate adjustment holes on each end of the bar... It is a completely bolt on sway bar.... If it's just a street car the 1" will be fine..

The 1" Bar - Front hole 722 lb/in / Rear hole 947 lb/in

The 1-1/8" Bar - Front hole 1084 lb/in / Rear hole 1422 lb/in

 

[bishir]

Ridetech Bar. You'll need to have their LCAs to work. Sorry about the quality.. Phone pics...