Powerlogger blm cell highlight

Roc87

11 Second V6
Joined
May 25, 2001
Updated the powerlogger with the newest drivers and key on/engine off I can click in the blm cells and a window pops up to enter the new number, I enter the new number and the cell shows the change for a second then reverts back to what it was. Any ideas what's going on?
 
I would check again that you have the latest Powerlogger software. PLC version 2.5.2.

Also, make sure you reflashed the Powerlogger board with the newest PL044 file.
 
Oops, I didn't reflash the board.

BTW, just shipped a chip to you this morning, will be ordering a e85 6.1 from you tomorrow or Thursday.
 
Top