Parts at Bowling Green

chris

Member
Joined
May 24, 2001
Parts that will be at Bowling Green.
Large parts pre-pay since I'm limited on space to transport.

8445 heads - $50 set - sold
2004R transmission - fresh rebuild by DynoTech, only driven less than 5 miles and 2 qtr mile passes. NLU with deep pan. $950 - sold
Torque Converters for 2004R -
PTC 20 blade NLU - good for big power and higher RPM's - $825
Vigilante LU single disc, 3600 stall - low miles - $400
Unknow brand NLU -10" - $175
SpoolFool front and rear fillers - new - $600 - sold
Fiberglass front bumper - new, from Kirban - $150 - sold
PowerLogger and stock ECM - $300
Large aluminum radiator -16an fitting welded, stock size with trans cooler only - $300
Dynamic EFI system with low impedance driver box - $650
Stock intake, bare, ported with oblonged mounting holes, welded EGR - $125 - sold
MT drag radials, new - 295-50-16 - $400
Stock turbo cranks, assortment - will need cleaned and possibly turned - $150 each - sold
Turbo 400 transmission out of 73 grand prix, short tail shaft, stock with 83k miles - $400
Accufab AFP regulator - $90
Inner cooler fans - $50 each
ATR front mount inner cooler - $450
Stock inner coolers -
clean ported, bare - $125
dirty with up pipe and shroud - $75
Underdrive pulley - $50
8.5 vector rims, includes centercaps - nice condition - $400 - sold
Factory headers - repaired - $200 - sold
Factory headers - need repaired - $100
Factory header modified for external wastegate - $100
Factory crossover pipes - $50
Remote oil system adaptor, lines, filter housing - $100
Drag tire tubes - $50
Factory streering box, 92k miles - $100
Manual S-10 steering box - $100
Factory tensioner - $100 - sold
TB, doghouse, steel vacuum line - $100 - sold
Fuel rails - $50
Throttle bracket and coil pack bracket, chrome - $100 - sold
Coil pack plate - $35
Champion head clamps - $75
Piston press for stock pistons - $200
GN center caps - used set of 4 - $100 - sold
GN center caps missing turbo 6 emblem - $10 each - sold
Pics and more parts to come.

Prefer to deliver large parts to BG.
Buyer responsible for shipping fees.
 
Last edited:
Does the factory header that is welded for an external WG come with both headers and crossover, or just the passenger header?

What kind of WG is it setup for? V-band style?
 
Top