Oil leak

turbinetom

Active Member
Looking for advice on control arms and caster. I want to build my own control arms using the stock ones to build a fixture. I want to push the upper ball joint to the rear and move the lower fwd. doing this to keep spindle centered. Any advice on how far to move each location?
Yes I know I can go buy a set but it robs me of the satisfaction of building my own parts
Thanks
Tom
 

turbinetom

Active Member
Jfsram
Thanks for your reply, justy seeing this now. Yes, I want to lean the spindle back but maintain the original wheel position relative to its location in the wheel well. I know some aftermarket arms have the ball joint location kicked forward and aft to do this...just wondering how much I should move it.
 
Top