Cryptic
Active Member
- Joined
- Aug 6, 2001
I just wrapped up replacing my timing chain. I am getting oil pressure and it is cranking but not starting.
I've done some basic troubleshooting:
I'm sure it's something simple but I can't quite figure it out. I haven't touched anything else on the car aside from that gauge wiring during the timing chain replacement in fear of having an issue and adding more variables and am now glad that I did! Any guidance would be appreciated!
I've done some basic troubleshooting:
- I am not getting any spark
- I am getting fuel pressure but it does not appear that the injectors are firing (based upon cranking and dry spark plugs, I am picking up a noid light tomorrow to validate that 100%)
- I replaced the crank sensor due to damaging the crank sensor bracket (short version: I'm an idiot) but based upon what I'm reading a crank sensor only affects spark and not fuel
- I set the cam sensor using Casper's tool, after the no-start condition I set it again this time with a buddy to supervise me
- Just in case the wiring I did blew a fuse (see below) I pulled and checked all fuses that seemed like they would be relevant
I'm sure it's something simple but I can't quite figure it out. I haven't touched anything else on the car aside from that gauge wiring during the timing chain replacement in fear of having an issue and adding more variables and am now glad that I did! Any guidance would be appreciated!