Complete pull out from a 1986 T-Type. Engine, Transmission, and Harness.
Engine:
.030” over Sealed Power Pistons
Edelbrock 204/214 flat tappet cam
Double roller timing chain
New Gaskets
H&R Motor Mounts
Mini Starter
MSD 50lb injectors
Stock exhaust manifolds and crossover, no cracks
New Alternator from Advance with a lifetime warrenty
Garrett TE60 Turbo
Full Throttle Turbo Tweak Chip
Wiring Harness/Computer included
Transmission:
Rebuilt Brian Hofer Transmission 200R4
New 10.5” 2800 stall convertor
Trans/Convertor have approx 4000 miles on them
I purchased this engine/trans from a wrecked T-type from another board member on here. (See the link below) I do not know for sure the mileage of the motor, but the bearings were stamped 2004, so I'm guessing it was rebuilt some time around 2005. I’ve decided to take this project in a different direction. I tore the whole motor apart, cleaned and inspected everything, then reassembled the motor. While the engine was apart, I dropped one of the lifters and chipped it, so I installed a new one. This will require the engine to be ran at 2000 rpms for 30 mins upon initial startup.
http://www.turbobuick.com/forums/cars-sale/297833-wrecked-my-car-sale-pics.html
I prefer local pick up at this time. I am located in Mooresville, NC, about 20 miles north of Charlotte. Please feel free to call with any questions.
$2150.00/BO
Marc
704.507.7033
Engine:
.030” over Sealed Power Pistons
Edelbrock 204/214 flat tappet cam
Double roller timing chain
New Gaskets
H&R Motor Mounts
Mini Starter
MSD 50lb injectors
Stock exhaust manifolds and crossover, no cracks
New Alternator from Advance with a lifetime warrenty
Garrett TE60 Turbo
Full Throttle Turbo Tweak Chip
Wiring Harness/Computer included
Transmission:
Rebuilt Brian Hofer Transmission 200R4
New 10.5” 2800 stall convertor
Trans/Convertor have approx 4000 miles on them
I purchased this engine/trans from a wrecked T-type from another board member on here. (See the link below) I do not know for sure the mileage of the motor, but the bearings were stamped 2004, so I'm guessing it was rebuilt some time around 2005. I’ve decided to take this project in a different direction. I tore the whole motor apart, cleaned and inspected everything, then reassembled the motor. While the engine was apart, I dropped one of the lifters and chipped it, so I installed a new one. This will require the engine to be ran at 2000 rpms for 30 mins upon initial startup.
http://www.turbobuick.com/forums/cars-sale/297833-wrecked-my-car-sale-pics.html
I prefer local pick up at this time. I am located in Mooresville, NC, about 20 miles north of Charlotte. Please feel free to call with any questions.
$2150.00/BO
Marc
704.507.7033
