Looking for 4 inch inlet k&n airfilter

I have a used aFe one that came with my TinMan under-bumper cold air induction kit. It is an early version of aFe part number 72-40035 ... 4" inlet with 6" wide at the bottom tapering to 4.75" at the top, and a 9" pleated filter height. I can attach pics tomorrow if this would be if interest. It's in good condition, I cleaned and re-oiled it recently. i replaced it early this year for my smog test just to make sure I passed, so I no longer need it.
John A, Turbohh
 
Here's pics of my used aFe piece ... There's a small hole in the small end that was used to fasten the filter to the frame bracket, which can be easily plugged if needed. ~10.5" long with 9" pleated filter length, and the inlet diameter is 4" as seen in the pics. Has a couple of spots where the pleats are a bit scrunched, but there are no tears or holes in the mesh or filter media. As I said, I cleaned and re-oiled it recently, and is unused since. Asking $45 shipped in the lower 48 Unites States. This is one of the ones you need to clean and re-oil periodically ...
John A, Turbohh

100_6697.JPG100_6698.JPG100_6701.JPG100_6696.JPG100_6702.JPG100_6699.JPG100_6700.JPG
 
Top