GNX DASH INSTALL

BILL HAINES

R.C ENTOURAGE
THANKS FOR POSTING THE PHOTOS JOHN! YES, WE'RE INTO IT! MAN, MY STEERING WHEEL LOOKS LIKE CRAP! GUESS I'LL NEED TO GET IT RECOVERED..
 

BILL HAINES

R.C ENTOURAGE
I TALKED TO RICK HUNT TODAY. HE HAD SOME VERY GOOD ADVISE AND INFO FOR MY PROJECT(WHAT A NICE GUY!!) LOOKING FOWARD TO GETTING BACK ONTO THE DASH INSTALL THIS WEEKEND...THANKS AGAIN RICK!!!
 

BILL HAINES

R.C ENTOURAGE
YES HE DID, HE SAID ITS BEST TO MAKE A NEW LOCATION THROUGH THE COWL,MAN I'M GLAD I TALKED TO HIM PRIOR TO GETTING THAT FAR!!!
 

RIFF RAFF

CAN'T MEMBER
I JUST DIDNT WANT TO SEE YOU ON THE SAME ROAD I WENT DOWN .. I FOUND THE TIP IN ONE OF RICKS OLD POST'S WHEN I FOUND THE ANSWER 2 SPEEDO'S LATER .
 

BILL HAINES

R.C ENTOURAGE
I SPOKE TO JOHN ABOUT A YEAR AGO REGARDING THE WIRE HARNESS, HE SAID BE SURE THAT I HAVE A GASKET OR SIMILAR ITEM BETWEEN THE METAL HOUSING AND LP BOARD OTHERWISE IT WILL SHORT OUT, BUT I DON'T REMEMBER ANY GROUND ISSUE.. CAN YOU EXPLAIN???THANKS..
 

RIFF RAFF

CAN'T MEMBER
ONE OF THE GROUND WIRES DID NOT MAKE THE CONNECTION SO WE JUMPED IT . ALL'S GOOD THEN . I THINK IT HAD TO DO WITH THE SMALL GAUGES ONLY . AND COVER YOU COLUME OR IT WILL GET PAINT DAMAGED .HTH
 

X Ray

The GNX changed my life!
Pictured below are the parts needed for a complete GNX dash installation....and a picture from under the dash of the new hole location in the firewall to prevent the fluttering of the speedometer, note the proximity to the powermaster. This is a one inch hole to match the grommet. I do not know the grommet size of the aftermarket cable if there is one. Thanks for the kind words.....regards rick
GNX dash parts001.jpg
GNX dash parts002.jpg
GNX dash parts003.jpg
Hole Location.JPG
 

BBcallaway

Member
Hey Rick, is the GNX dash hard to get out? Are the bulbs easy to change. Mine are kinda of dim and would like to change them.
Thanks. any tips to make it easier?
 
Top