Finally getting closer

qwksht

Member
Finally getting closer to my swap, engine is done and about ready to pull the oil leaking headache of a 6 to install this beast
IMG_1705.JPG
IMG_1705.JPG
 

Attachments

  • IMG_1706.JPG
    IMG_1706.JPG
    1.5 MB · Views: 110
  • IMG_1707.JPG
    IMG_1707.JPG
    2.1 MB · Views: 106

Fat Nat

Well-Known Member
Good looking piece. I have your twin
 

Attachments

  • 2673F690-C7FA-4EAD-8B9B-25E5E3B02F31.jpeg
    2673F690-C7FA-4EAD-8B9B-25E5E3B02F31.jpeg
    939.4 KB · Views: 139
  • D740D4B6-FD62-49D3-9BDC-8E63BA593DBE.jpeg
    D740D4B6-FD62-49D3-9BDC-8E63BA593DBE.jpeg
    1.4 MB · Views: 143

hemi8

Goin Sideways
Nice! And I bet your intake didn't cost 3500.00 either........dang, if I could do it over.
Mike
 

qwksht

Member
Did you have any hood clearing issues with the high ram intake?


Unfortunately I still haven't put the motor in the car yet,i have been so busy with work that I haven't had the chance to install it yet,hopefully I will be putting it in within the next few months
 

TT/Ameasap

The White Blur
You sir, will not regret this swap at all. I just finished my LS Turbo C10 and the power you can make safely is stupid on a stock motor. I have not looked back , but I do miss the people here.
 
Top