TR6 Ignition Software Install Concern

Chuck Leeper

Toxic old bastard
Staff member
Joined
May 28, 2001
Instructions say if you have a ballasted system to connect the red wire to the ballasted resistor. The 75 has a ballasted wire from what I see and have read. So where does the red wire attach, directly to the coil but then I have to remove either the ballast wire or white wire from fuse box.
A bit late there. This thread is 3 yrs old.
BTW, this smells a bit like a troll attempt.
If it's for real, start a new thread and go from there.
Otherwise, it's not going to continue.
 
As far as the OP, I went to his place and updated his unit (a couple years ago)
as far as the troll..... I have no idea what they are talking about. I presume they will be kicked out soon.
Bob
 
As far as the OP, I went to his place and updated his unit (a couple years ago)
as far as the troll..... I have no idea what they are talking about. I presume they will be kicked out soon.
Bob
Exactly what's about to happen.
I couldn't make heads/tails of his/her gibberish, either.
It's gone!
 
Top