Complete 3.8 stroker

deleonl

N.S.D.Q
Joined
Jul 9, 2001
3.8L Buick block (249 Cubic inch)

270-Stroker 4340 billet crank (3.625)

Molnar Technologies 5.960 rods

Pro-Gram engineering billet main caps

RJC Girdle

Front cover with high volume oil pump

BHJ Internal balance harmonic balancer

J/W flexplate

Diamond pistons with total seal rings (.20 Bore)

212/212 roller cam

Iron Kenne Bell ported heads with large values

1.65 T and D shaft roller rockers

Accufab 70MM TB and matching Plenum

GN1 valve covers

Stock ported intake

Stock fuel rails

Seiman low-z 83lb injectors with modified ECM

The motor will come with everything you see in the picture to include an ECM, two turbo tweak chips – one for alky and the other a 91 street chip. This motor is complete and ready to drop in. I can remove AC unit, alternator, and PS pump if you don’t need them. I have all the paperwork for the build.

Located in San Antonio, TX

Willing to ship at buyers expense.

8k obo

Quick history of the motor. Built in 2018, ran for about 2k with no issues. Pulled and replaced with a built turbo LS1. Short block was built by a shop in Houston, TX.
1208191709.jpg
1208191710.jpg
1208191710b.jpg
1208191714.jpg
1208191710a.jpg
1208191714a.jpg
1208192037.jpg
1208192019.jpg
1208192018.jpg
1208192020.jpg
 
Wow very clean and cool. There is a roller GN in the cars for sale section for 11,000 plus this stout build. It would be great to bring the two together for a match
 
I decided to part motor.

Short block has been SOLD.

Will list heads, intake, TB, etc...later on a separate post..

All PMs answered.
 
Top