Aerospace fronts, how to route braided lines?

Buickturbo85

Loves The Buicks
Joined
May 29, 2001
This seems like a basic question, but I want to ask so I don't screw this up. On my Aerospace front brakes, I'm not sure how to route or secure the brake lines so they don't rub anything. No matter how I position the line, it will contact either the spindle or the sway bar link at some point in suspension travel. It looks like I can zip tie it to the spindle a few inches below the ball joint so that it wouldn't contact anything. Would this be OK to do? Or is there a better solution I'm just not seeing? Here's some pics:

DSC06488.jpg

DSC06484.jpg

DSC06485.jpg

DSC06487.jpg

DSC06486.jpg
 
I always split a rubber/silicone hose and ziptie in place when I am concerned about wear.
mart
 
Top