A thread of pictures

T- Type Tim

Vice Chairman
Joined
Jul 8, 2001
IMG_3185.JPG
IMG_3149.JPG
IMG_3146.JPG
IMG_3145.JPG
IMG_3121.JPG
 
Give Scot a holler at gns
He hooks up board members pretty good

Fixin to order a set of front coil overs here pretty quick
 
A re spring was needed. I went from a 12" 110lb spring to a 14" 150lb spring. Now i dont have to crank up the preload to set the ride height.
IMG_3195.JPG
 
275/60/15's on a rim with a 4 inch backspace will clear the frame and wheel lips with ease.
 
Iirc those are 275/50/15 mt's on 10 inch wide jegs rims. Those tires run really wide and measure almost 11.5 inches (my buddy has them on his cobra). I remember all the numbers cuz i was planning on ditching my gta wheels for the same setup for street duty
 
Iirc those are 275/50/15 mt's on 10 inch wide jegs rims. Those tires run really wide and measure almost 11.5 inches (my buddy has them on his cobra). I remember all the numbers cuz i was planning on ditching my gta wheels for the same setup for street duty

Take a look at the pics. Fairly certain on the inside of the tire it says 275/60/15.
 
So it does... on the jegs wheel thread a couple months ago there was him and a brown one, the brown one was running 50's. But theyre still 10" wide rims, they look mighty close to the lips
 
So it does... on the jegs wheel thread a couple months ago there was him and a brown one, the brown one was running 50's. But theyre still 10" wide rims, they look mighty close to the lips

I'm running 60's. You really need to make sure the rear end is centered. Roll the fenders and I would recommend coil overs.


Sent from my iPhone using Tapatalk
 
Rear end in my car isn't centered...and I use 275/60/15's and 28x9 slicks on 8 inch rims with a 4 inch backspace and they fit no problem.
 
yup they are rolled...the deal with these rims is they only make them in 4.5" backspacing for the 10 " rim......they are real close


thanks for the compliments fellas
 
Here is my rear end . Eaton true trac with 30 spline moser axels and C clip eliminators . I also welded the axle tubes to the center section . I fit a 10.5 x 28 x15 without a frame notch . Just need airbags to stiffen the rear up or else it would rub the inner fenderwell . I also have the s10 7/8” brake upgrade and a TA diff girdle
F432F09D-82F7-4267-93EA-8CFA2C92797B.jpeg
02398A42-0A69-4E1C-95B1-54DBAD003084.jpeg
BFAD8FBD-BDC7-43FD-B977-705B8A8FB7E1.jpeg
 
Top