3 1/2" downpipe, 2 1/2" ATR cat back, Houston headers, Weldon pump...

highpsi87

Twisted obsession
Joined
Oct 20, 2008
3 1/2" stainless downpipe, not 100% confident on the brand as I purchased it through a 3rd party but it was new when I got it roughly 4 years ago. Maybe a guru here can help jog my memory. I did have to slightly massage the header side for clearance . Comes as shown with DEI wrap...450 shipped

Dump pipe for 3 1/2" downpipe, not stainless...65 shipped

2 1/2" stainless ATR dual cat back system. I used a da to clean up the system a few years ago so the stickers are gone. It sounded great! I've gone a different direction and decided not to keep it, probably will regret this...550 shipped

Weldon 2015, no issues. Not sure why guys say these are noisy unless they run it wide open all the time. This one was always run with Weldon's fuel pump controller and I have no complaints...300 shipped

Terry Houston stainless headers and crossover, had them since new. Passenger side flange was machined flat and had them coated black a few years ago but it didn't last. Will clean up nicely though, V band clamps included...650 shipped

39mm Precision wastegate, new as shown...200 shipped

Original gas tank complete with Red Armstrong double pumper for local sale only...450

The included shipping is to the lower 48...
 

Attachments

  • 20180921_195530.jpg
    20180921_195530.jpg
    639.4 KB · Views: 266
  • 20181006_151534.jpg
    20181006_151534.jpg
    545.3 KB · Views: 268
  • 20181006_153223.jpg
    20181006_153223.jpg
    732.8 KB · Views: 275
  • 20180921_195407.jpg
    20180921_195407.jpg
    712.7 KB · Views: 271
  • 20181006_150455.jpg
    20181006_150455.jpg
    599.1 KB · Views: 279
  • 20181006_121039.jpg
    20181006_121039.jpg
    659.3 KB · Views: 279
  • 20181006_150735.jpg
    20181006_150735.jpg
    1.3 MB · Views: 288
  • 20180921_195615.jpg
    20180921_195615.jpg
    493.8 KB · Views: 254
  • 20181006_154959.jpg
    20181006_154959.jpg
    1.4 MB · Views: 232
Downpipe, dump and wastegate sold...Houston headers and Weldon pump still available.
 
Not sure what specifically you are asking for on fit. I was running them on ported aluminum GN1s which they fit well. Swapped the Houstons for TAs and other mods hoping to overcome a backpressure issue. Of course the 3" THDP I had cleared them, the TA 3 1/2" DP needed a little convincing to clear them.

Sent from my SM-G930V using Tapatalk
 
Not sure what specifically you are asking for on fit. I was running them on ported aluminum GN1s which they fit well. Swapped the Houstons for TAs and other mods hoping to overcome a backpressure issue. Of course the 3" THDP I had cleared them, the TA 3 1/2" DP needed a little convincing to clear them.

Sent from my SM-G930V using Tapatalk
Ok thanks. Strongly considering these.
 
Top