Search results

1) What is hex size?? 2) Any recommendations as to where to get an AC Delco replacement?? Thanks, Bob K

Below is my engine info...have driven the car very little over the past 6 years...total of 700 miles. Had not changed oil during that time...an oversight. The car resides in a heated and cooled concrete floored pole barn...temp extremes are 40F to 74F. So I take it for an infrequent drive 3...

I rent an Eastwood Fender Roller to Turbo Buick members.. He asked to rent it late last year. He received it right around Christmas. Never paid. Took weeks for me to get a confirmation that he had it. Then many weeks before contact again...I believe his sister has some serious health...

He's had my Eastwood Fender roller since 31 Dec...and I want it back. Unable to contact him. Thanks, Bob Edit: How does spell check change "from" to "or"...sheesh.

Great looking car!!! Driver about 60, whiteish hair, whiteish beard, maybe a tatoo on inside left forearm. My son is visiting PHX and saw you...took a nice picture as you made a hard left turn....gave you a "thumbs up" Be glad to send you the picture. Bob

So the car has sat pretty much for 1.5 years...heated garage. Got it all spruced up and ready for the track and headed off to Indy. Car started and ran trouble free for 60 miles. Got to the track and decided to do my first run at 100% street setup and boost limited to 17.5. As a precaution I...

I get this now when I try to open turbobuick.com. What is it??? And more importantly how do I get back to normal?? Thx, Bob

Wanted to insure all can see what has taken place. Bob K

What is wrong?? I've looked thru CP for something to edit but can't find anything. Candidly, I don't care much for this new website software. Bob K

Used to be able to do it in the advanced search. Now when I try it tells me no results (or something similar) when I'm looking for my own posts???? Have to be honest...I prefered the old format. Bob K

And will we ever be able to search like we used to be able to search again?? Bob

When I do what I think is needed it tells me that there are no matches...but I'm searching for my own username ??? Thanks for an "How To". And what is a "tag"?? Bob

And do you tighten them only once to the spec or go around and hit them all a second time?? Thanks, Bob

or the slot width on the balancer/damper?? Thanks, Bob

This is for the Chinese timing cover where the seal installs from the front and seals on the damper...not the crank nose. National Seal S-12623 or K100674R. FelPro 15200 is supposedly the same seal. Have a National Seal #710613 for sale or trade :) Thanks, Bob

I have 2 bolts longer, by about 1/4", than the rest but have lost track of where the long ones are supposed to go. This is an aftermarket pan that included these bolts...so I am unsure if 2 should be longer than the others and go in a specific place, or did I just get a handfull of bolts with...

Always wondered...finally asking :) Bob

Trying to remove the single large capscrew that hold the balancer on the crank nose...can't break it loose. Is it a standard thread or left hand thread?? Thanks...Bob

I posted in WTB looking for a cork trans pan gasket and Lee responded by sending me one. Wouldn't allow me to pay him for it. He's also given me some good advice over the years. Thanks Lee...hope we meet some day. Bob Kolhouse

Cork, rubber, steel embossed w/rubber, or ??? I have a welded alumunim sheet metal deep sump trans pan. When initally installed I found some seeping thru the welds. Had a guy reweld to try to seal...I may be again experiencing this instead of a gasket leak. Is there a sealant, Right...