Search results

TA49 with polished compressor for sale, will post pics later $450

Looking for a good used turbo, TA-49 or TA-60 or similar

Wow, this place has become slow, not much mention of upgraded turbos for our hot air blocks I see. Any rate, I have or had a reclocked TA-60 that decided to have the compressor wheel kiss the housing, which destroyed the compressor wheel. This will be a costly repair so I am contimplating...

How are you guys insuring your cars? I definitely want full coverage, finally got my car almost completely restored. What kind of rates are you paying and how much is everyones car valued at? I found this at NADA

What should I be looking for if my transmission only moves forward with lots of throttle (more TV I'm guessing) Reverse is great. Neutral is fine. Park works really good. I did drop the pan and cleaned the valve body thinking of a stuck valve, but I still have the same problem... This...

Will the output shaft turn in reverse by hand before fluid is poured in the pan? 2004R is in question.

What is recommended for a 10-12 second quarter mile street car? Just alto reds or are borg Warners ok with factory steel plates

What would cause a couple second delay to drive? Reverse goes in gear like it should quick like, just drive is slow to engage or something. This is in a 2004R with art car shift kit and recently rebuilt with type F fluid, add yes it is full. TV cable is good. Shifts fine and operates good...

Well, not sure how to upload the file but if someone can explain how I will, or I can email it... Just got the car back together and cannot figure out why I am getting a little bit of knock just from powerbraking out in the street. All I am doing is building boost against the brake. I turned...

What is an optimum ring gap for a stock bore and stock turbo piston? .010-.020 seems vague. I will be using speed pro moly top ring and cast 2nd ring

What is the optimum ring gaps for a stock 3.8L piston in a standard stock bore? .010-.020 seems vague to me. I will be using Sealed Power moly top rings and iron second rings

Can someone give me pointers on how to install new aftermarket inside sweeps. Looks like the original sweeps are stapled on to the upper door panel . Not sure how I can do that with the new ones as it has an aluminum support on the door panel.

I need both sides of each, let me know what you got

Have any of you guys had a need to restrict some oil going to the turbo? I have had an ongoing problem with my modded TA49 getting oil on the cold side and yes it does have a carbon seal retrofitted that I got from Limit Engineering. Right now I have a standard brake line plumbed from the...

What primer is everyone liking now days under PPG single stage DCC9300? K36 still good? I read in some post somewhere there was something better, but I can't find the post that says what it is. Maybe DP90LF?

Can someone please link me to some good directions on replacing my drivers window. I took the whole assembly apart way too far trying to replace my motor and can't figure out how to get it back together correctly

I have an extra usb cable for sale, model GUC232A, and I can give you the drivers and a copy of turbolink v4.0 on a cd. All you will need is a laptop and an OBDI connector and you will be all set for a cheap scanner $20 shipped

Anyone have a deep pan they want to sell that will fit with the 4L60 filter or anything better?

Well, years ago I said I would post some pics of how I did this, and I finally got around to pulling the intake off to modify it for alcohol injection, and put my carbon seal in the turbo, so now was the best time to clean everything up. The 1st pic is how it all turned out, 2nd pic is what was...

Can someone please send me or link me to pictures of a disected hot air intake. A picture of one cut in half down the top of the intake looking from inside out would be great!