Search results

Looking for 2 of these. Didn’t realize they were hard to find. Im in Jax FL.

Looking for low mileage or new set for 86

So, I finally got the car going after changing gas tank, fix fuel line in tank, mini starter (sounds weird vs orig), new front tires and battery. And a fuel filter Take it out, seems to run fine but any slightly decent amount of throttle causes a pop and spike in boost. The spike is basically...

Like the title says, I go to start, and pump primes, but gauge directly on fuel rail shows no pressure and car will just crank. Obviously it won't start due to lack of fuel. A little background. This is the time starting since replacing the fuel tank and the starter. I did unplug the fuel pump...

Lot of GNs from 2007, mostly black. Includes some other hot wheels & misc collectible cars. Looking for $75 shipping in U.S. Only. PayPal only

It's been awhile so I have to figure out how to post pics, but looking to sell a stock exhaust elbow ported by TurboMike back in the day from this board. Asking $100 shipped in the U.S. only.

Just installed jeep shaft, now car is leaking out the radiator cap. Looks like fan isn't going on, dual fan setup. Could I have unplugged something? It's been a while since I have worked on this, so I forgot. Thanks

I have some old chips for 009 injectors, a modern muscle 93 chip, Jim testa alc chip, and an unknown 110 oct chip. Do these have any value? If not for usage, then for the chips & carriers?

Looking for one, clean, inexpensive, with writing on top, no tube needed

Anyone make one that says "engine oil"

I didn't see any posts, did I miss them? Car & Driver has them. I didn't read the full article, it might be a wish list. GN in colors? Turbo 4 cyl or na v6? GNX seems right but that should be the base GN motor. I hope if its real, they make some changes.

I have some items I want to sell, not car related. I wont list them here unless I can. BMX stuff, Star wars, starting lineups, etc. Thanks.

considering doing this upgrade, looking for shaft and all parts needed.

I was looking through pop mech magazine and they had cheap portable welders. I was thinking i could use this to weld relocation brackets on the rear diff. Anyone ever try these? Harbor freight has one for $90. I wonder if it will do the trick.

I just bought one from jegs, and it has no markings on it. Just a misaligned sticker. All of the ones I have seen are stamped, but they are older.

I have a cracked pro star thats 15x6. 2nd one thats cracked. I was thinking about going to the Weld RTS 15x6.25 w/ 3.5 bs instead. Same weight, but I think they are stronger too, not just for a straight line. I will leave the pro stars on back, they seem fine, and will almost match. Any real...

looking for 1 15x6 weld prostar, or possibly 2 15x5 or 15x4 rims mat extender, the extention harness i think caspers sells gray 2 gauge pillar pod

Looking for above in decent condition. My zip 32082

Just noticed the other day, one of the spokes where it meets the rims towards the tire is starting to crack, a hairline. I had one back in 2005 do the same thing on the pass side, and that time it did it slowly until all spokes were cracked. I actually thought it was just the clearcoat until I...

Hi, trying to tune this MER, I can only get the #s to increase regardless of a/c setting. I have tried charging the battery due to low voltage, but doesnt work. Does Steve still have a website, or does no one use this system anymore? My computer is down, so I cant check back for a day...