Search results

ok guys so I've got a new TA block I'm wanting to go 4inch bore have a stroker crank and wanting to be last cam I get. Right now I have springs enough to go 625 lift. Currently just have ported gn-1 heads. have 1.6 ratio roller rockers. Am planning on going e85 and 9.5:1 compression ratio...

im planning o. Going e85 my friends finally convinced me to go! I'm wanting to go mid nines how big of injectors do I need I've had bob bailey modify the ecm with peak and hold drivers! I was planning on getting Eriks 120s and chip combo but he's said they would be maxed in the high nines. So...

Well my transmission on my car is bad anyone did a switch to a 700r4? Or is it more cost effective to have one built? Any thoughts or advice? I've heard the 700r4 is excellent and horrible both ways...which way is best?

When I turn my car on. The scan master won't come on. When driving every once in a while it'll come on say 2.1 then go off. And suggestions of what might be going on?

I'm having issues finding where all the wires go in my engine compartment. One in particular it comes off the O2 sensor and has two pig tails on the end. Does anyone have a wiring diagram or know where these wires go?

So I've got my engine in the car and I don't have the timing tool with the light. Think its call a Casper. Anyway I was wondering if I could get a breakdown of how to do it with a multimeter. And if I do it with multimeter will it be as accurate? I ask this because when I start it I have to...

Ok so I'm debating aluminum heads or ported iron heads. Can anyone tell me how the Aluminum heads compare to ported iron heads? Ive been trying to contact champion to ask bout the heads and specs. And longevity of both comparative.

Recently found out my block was a hot air block! Need a good 109 block with good bore! No cracks!

Ok so after starting my build I'm having lots of little issues that I'm running into. Ok maybe they are kinda big lol my crank had to ne ground .030 have been told that the hp I'm liking at it needs junked next is if I get new crank is it worth the extra time effort machining and all that of...

Hey there! I live around the iola ks area anyone close by?

Hi there y'all . I live in ks and just recently bought an 87 gn. Well fuel pump went bad which causing me to rebuild it.(new to gas side of power so dumb probably). But why I'm postin is i have a few things to ask, first I'm looking for a great launching bottom end and great top end cam...