Search results

The reason I’m putting this post in the general discussion part is I’m not sure if it’s a transmission issue , computer issue or a chip issue. Last week while doing a shake down drive my car would stall when coming to a complete stop. This didn’t happen right away but only after about 8-10...

Car dies when I come to complete stop. I have 4 wires coming from the connector on the drivers side trans case. 2 go to the passenger front solenoid 1 goes to pressure switch on passenger side rear. The other one was not connected to anything and I cannot see anywhere it would connect to. So my...

Looking for a stock or next to stock turbo. Currently have stock turbo from 1986 and I can move shaft 1/4” side to side and I am getting a good amount of smoke out the exhaust. Appears to be no oil in the radiator and no water in the oil. I do google searches for stock replacement turbos but it...

86 GN with 105k miles. New cam(206/206) valve springs, new timing chain, new fuel pump, new adjustable fuel pressure regulator, new 60# fuel injectors with TT chip, new adjustable cam sensor cap, new plugs and wires. Car will start but won’t idle and if I give it a slight amount of throttle...

I’m going to look at a used Garett 32 mm turbo is there anything I need to look for?

My powermaster motor failed probably due to not being used in 10 plus years and moisture. I replaced entire unit with a vacuume set up out of a 88 Monte Carlo. Completely re built rear brakes with new wheel cylinders. Tried to bleed with a vacuume bleader and no success. Disconnected brake lines...

Finally got my 86 GN running after tearing it down to do a mini restoration. Changed cam( comp cams 206/206), lifters, valve springs and timing chain gears. Reset both the cam sensor and TPS. The issue I’m having is that I have to pump throttle to get it to start. Kind of like an old carb. Once...

I have 2 electrical connections that I need help to figure out where they go. 86 GN thanks

Where does the short throttle cable go to. I have the one from the trans to throttle body and the one form the gas peddle to the throttle body hooked up. I took a lot of pics when I disassembled ever

Finally getting my engine back together as I was cleaning up the turbo for reinstall I noticed that there was oil coming out of the waste gate actuator. Is this normal

Is the curved piece that goes at the bottom of the windshield body color or the trim black color?

Ok looking for some input I have a 86 GN in the middle of restoring. It's a almost rust free ( couple small spots) completely disassembled we want to insure it for what it's worth but I have no idea what that is any suggestions ?

Ok a little behind the times as far as the computer controlled cars i am mechanically inclined not computer literate so I plan on 60# injector /chip swap for e85 what else do I need for a street car not worried about mpg also motor is being rebuilt so any internal mods that need done that I...

I have an 86 gn that I have had since 97 quit driving it about ten years ago I plan on new headliner fresh paint tranny and engine rebuild. I would like to increase hp up to about 300 -400 range not looking to go racing just like good street machine any suggestions and comments