Search results

  1. H

    Long block needed!

    How much for an intercooled one? Precizion818
  2. H

    Long block needed!

    What's your number or email? And what would a good time be to call?
  3. H

    Long block needed!

    Gotcha, I'm looking for an almost whole engine. Thank you though!
  4. H

    Long block needed!

    Awesome! Thank you. I am in ms but I could drive a couple hundred miles thats a pretty great deal! Thanks!
  5. H

    Long block needed!

    Awesome! Thank you. I am in ms but I could drive a couple hundred miles
  6. H

    Long block needed!

    i am looking for either a hot air or intercooled long block. All I need is the block, crank, rods and Pistons. Thanks! -harlie
  7. H

    Stock ECM

    Yes sir! Thank you! @TURBOTIMMER
  8. H

    Stock ECM

    That would be great if it has the cal pack! And yes I'm in MS @TURBOTIMMER
  9. H

    Stock ECM

    I really need a Stock ECM with the cal pack chip Thanks in advance!
  10. H

    Stock ECM

    Duh! Stupid me lol thank you sweet6
  11. H

    Stock ECM

    Wasn't sure exactly where to post so I just put it with the electronic section. Move if needed but anyway... Does anyone know where I can get a Stock ECM with the cal pack chip? Thanks in advance!
  12. H

    TE44

    Sorry I misread it say 2012.. Not 2015 :/
  13. H

    TE44

    Very interested! Pm sent
  14. H

    GN mechanic/help!

    whos the best GN specialist/mechanic within like 300 miles of Jackson or Hattiesburg MS? Really need and want my car running again. Thank you!
  15. H

    PLEASE help! Sputtering

    This is the E3 spark plug I had in it. I replaced these after just two weeks And just my luck.. It's the only car I own so I drive it to work and I just got gas and went to leave and it died in the middle of the street then wouldn't start! I'm pretty sure it's the starter again because it's...
  16. H

    PLEASE help! Sputtering

    This is a picture of one of the recent spark plugs I replaced. It has a little more junk on it then when I first pulled it out because it's been in my toolbox. And it's not a putt putt kind of sputtering it like shakes back and forth as if it doesn't wanna go I don't know if that will help...
  17. H

    PLEASE help! Sputtering

    Alright gotcha! Thanks for the advice and I should have a pic by around 2.
  18. H

    PLEASE help! Sputtering

    I've replaced the PCV valve and the line that goes to the vacuum block. And no I haven't done a compression test. How or where could I get that done? I don't know if this matters but I also have oil on the vacuum block
  19. H

    PLEASE help! Sputtering

    Yes sir! I will. They are white tip with a little bit of oil around it. I'll take a picture as soon as I get home!
  20. H

    PLEASE help! Sputtering

    I've tried ngk, E3 and ac delco. Nick micale
Top