Search results

I'll post a log with the volt booster vs the BAP. With no other changes, I feel my AFR was more steady and half a point richer with the BAP. Also.....i noticed no other difference in how it ran without the volt booster........ i.e: more voltage for coil, injectors, etc. In my opinion......If...

I just switched from a volt booster to the boost-a pump. I went to the track yesterday and was impressed. There was nothing wrong with the volt booster, i just got a good deal on the BAP and liked the idea of it. I Checked and double checked that it was sending the correct 17 volts to the...

Brand new with original box and instructions. Only installed with engine on stand. Never ran. $60 shipped.

I'll buy that from you. whats your paypal?

sorry for the delay. between work and kids sports...... heres a log of a run at the track. from frame 2050-3000 was the burnout attempt. you can see it took several attempts and i was finally able to do a full burnout, then make my pass with no issues.

put me in line

i have a volt booster so i am at 15.7 .That was a thought i had. battery in factory location Once i get to my laptop, ill share a log.

Yes, it does it while the throttle is still held open.

Turbotweak 5.7 chip i have many logs. I've stared at them many hours to see if its something obvious losing power or signal. I usually start recording before i even get to the burnout box so i can focus. I'll dig some up and post them.

It happens while still holding the throttle open.

Hr engine mounts For a roller, i feel like the valvetrain is fairly quiet. Very rarely do i get a blip of KR on the shift I was kind of wondering if its pulling so much timing, causing it to lose power

Hoping for some input on a strange issue that has happened the last 3 or 4 times at the track. The car runs beautiful everywhere and every time I drive it. Cruising, highway pulls everything. Going down the track, the engine doesn't miss a beat, it pulls hard and very consistent. The only...

bump

Ill take the LCA's with links if they are still availible.

ttt. $150 shipped

$180 shipped Selling my bailey engineering 2-step rev limiter. Nothing wrong with it. I am switching to stand alone so i no longer will need this. complete with instructions. All you will need is a switch to power it on, and your desired way to activate it (I added a switch on the brake...

*UPDATE* Its fixed After 2 modules (original and ACdelco replacement), 2 sets of wires (used and new set), swapping out my injectors, and 3 coil packs. It was the coil pack. The 2 i had (origninal and new aftermarket) did not ohm out correctly across 2 terminals. I got that one warrantied...

I have 3 coil packs now. The one that’s been on the car to 20 plus years, and aftermarket that’s that’s 2 years old. And a brand new aftermarket I haven’t tried yet. 1 module that’s been on the car for 20 plus years and a new acdelco. I got a new set of plug wires yesterday and I have a...

I will do that today And report back

yes i have a volt booster. I have unhooked it several times trying to find this issue and no change. Sensor is about 2 years old. I have not calibrated it since i initially did when i installed it.