Search results

Lets Go Brandon!

One done, 3 to go.

My hot air thermostat housing is leaking, multiple pin holes, rusted, anyone have one for sale in good condition? Thanks, Spaulding.

She runs, tried to upload a 40 sec movie but the site didn't allow it.

Update: Checked crank sensor and found signal and ground were wired wrong (by me). I found this using the caspers website tech pages and putting my wire routing/diagram on notebook paper to keep it organized. Next, using a 5v wall charger for an old cell phone and a multimeter, I checked the...

Thanks Dan!

Computer and chip(s) if anyone is knolwledgeable please let me know if these look ok.

Yes, I just finished testing continuity from ccci to computer (5) total wires and all have good continuity and are in the correct locations. Still need to check white tach wire and trace it to instrument panel. Checked rotation of cam reluctor/interrupter under cam sensor cap and it is rotating...

Thanks, I have an old holly projection I was thinking of using but no manifold. I appreciate your input and will probably look around for an 86-87 manifold.

Hi Shawn Great job on your engine build. I am thinking of doing a similar swap, would you recommend getting the 86-87 intake manifold or are you happy with your choice of intake, throttle body, and injectors.

Guys here is what I have so far using Casper's sensor check tool: With key on: power, crank and cam lights illuminated (bright and steady) on test tool. With engine cranking over: power, crank and cam lights same, not blinking rapidly as stated in instruction sheet. Moving the switch on tool...

Here is where I am so far: Chart c-4a 1. no spark on 1,3,5 4. .3 volts at b-5 Chart c-4b 1. a-11 volts .3 2. a and b volts 6.4 2a. a and c volts 11.5 4. crank engine volts 4.3 steady, not varying The tree states: not ok faulty sensor I have replaced the cam sensor, and still have the same...

Thank you for your generous offer, I am going to make sure I have power at all sensors and the injectors, then check all fuses again. I will let you know if I need the tester. Question regarding the fuse block, do you know if any of the single point fuses labeled ign 1, 2, and 3 need fuses? They...

Just read it and will check it on my crank sensor tomorrow. Thanks for the pointers/tips.

Thank you, it looks like I have the correct computer for the car. Still have no spark and no fuel after new crank sensor, cam sensor and 86-87 ignition module conversion. Frustrating, back to the no start tree!

Hi guys, I am wondering if I have the wrong computer for this car, the label says factory authorized remanufactured module, service # 01226459, delco electronics made in USA. Thanks in advance.

Update: Replaced coil and ignition module, plugs are now wet but no spark. Working through the no start tree, getting close!

Hi Guys, I am at the point where I can crank the engine but have no spark. I have fuel to the rail at 45 psi but there is no fuel in the cylinders, plugs are dry. Following the no start tree, it shows the ignition controller is bad/failed. I am going to replace the ignition controller with a 87...

Thanks, that is exactly what I need!

I don't have a picture but can look for one and post it.