Search results

Curious which dummy indicator lights are supposed to work when new from the factory. Lt turn, Rt turn, brake, cruise, and service engine light up on my TR. I know the low fuel light was not an option for the TR but what is car is leveling and power injection? Thanks in advance.

Looking for a good working set of concert surround II dash tweeters for 87 T. Would also take all six CS2 speakers if you have them. Thanks in advance Posted from the TurboBuick.Com mobile app

Always great doing business with intercooled88s. Good communication and transaction. Posted from the TurboBuick.Com mobile app

Had the radio on while driving and noticed antenna didn't retract after I shut off ignition. Then noticed power locks and interior lights weren't working too. The 20amp CIG/CLK fused had blew, so replaced it with new 20amp. Everything works except now concert surround driver side dash...

Finishing my interior restore and I had this part left over. Not sure if it belongs under the dash or maybe in the engine bay. Is it use to organize the wiring or maybe it's not even an oem part? Thanks in advance. Posted from the TurboBuick.Com mobile app

Great communication, fast shipment and transaction. Will do business with again. Much Thanks.

Tried removing nuts on the escutcheon trim piece with the flat screw driver method and found it to work only on some of the nuts. I was afraid to use this method to screw the nuts back on to a new escutcheon because I couldn't get the nut to screw down evenly. Thought about using a hex key and...

Good communication, fast shipment and top notch packaging. Great seller and member.

Years ago I replaced my brake release handle when the cable broke. The dash plastic broke off where the handle sits when I pushed it in. I krazy glued the pieces back together but it broke again when reinstalling the brake release handle. Left it alone all these years with the brake release...

Reinstalling interior and was wondering if the quarter window panel needs to be glued to window. When I removed it, I noticed it had some black sealant on edges where it sits against quater window. Is the black sealant just excess from where the quarter window is attached to body? I noticed...

Putting interior back together and was wondering how much to torque seat belt bolts. Thanks in advance.

Finally got around to fix dash panel. Foam is warped and separated from the dash. I used Dap original contact cement (safe for foam) and a straight piece of wood. Apply cement to both surfaces and allow cement to set for 15-20 minutes before putting two sides together. Put the flat wood on...

What's the easiest and correct way to get these pieces in? The side trims are the last ones left in my headliner install and they were hard getting off but seam harder get back on. Been fighting with them last two days. Thanks in advance Posted from the TurboBuick.Com mobile app

What's up with people. Got another door ding in the parking lot. This time they left their car's paint on my door. It was like they had their door resting on mine and then used it to get out of the car. Left a dent and white marks. They tried to rub off their paint and left small scuff...

Wanted to see if I could repair speaker panel. The split was about 3/4 ways though. I used a soldering iron to spot weld underside of crack. Then got a thin paper clip and cut and bent zig zag pieces to use as reinforcement Using soldering iron I heated zig zag pieces into plastic, sand...

Planning to replace my old door lock covers with new black ones. What's the best way to crimp the new cover on and also not scratch them? Thanks in advance. Posted from the TurboBuick.Com mobile app

Redoing my interior and after removing headliner I found some surface rust on underside of roof skin. The area of the skin that has the light surface rust is above the roof reinforment rails and around the edges by windshield and doors. What's the best way to remove surface rust from these...

Looking for donor grey front seat cover to redo my drivers seat bottom. All my seats are in pertty good shape, but the drivers bottom portion has a tear in the center Palex section. The upholsterer said he couldnt fix it cause it wasn't close enough to a seam to hide the stitching. Just need a...

Want to keep interior simple. Which two gauges would be most important to have, water temp, boost, oil pressure? Didn't want to put anything on A-pillar. Thanks in advance.

Anyone else get paranoid when cruising their Turbo Regals? Final got TR out of storage, went for a cruise and gas station for air. Was filling tires and guy walks up and asks question about car. If it's a Grand National or Regal - I say it's just a Regal and go back to filling tires. He asks...