Very, very clean turbo, no shaft play, a few thousand miles and never seen above 20psi of boost. Always ran an extra pre-turbo oil filter or "turbo-luber" with it. $650 shipped to the 48.
Thanks,
Johnny
I'm at work and have about a 30min drive ahead of me to get home... my powermaster is acting up. Symptoms are rock hard brake pedal, no noise from pm, no brake light on, and very slow stopping (compared to what I'm used to). Also the pm fuse is not blown.
My question is, to the experienced...
Hey all, I'm interested in purchasing a clean to fairly clean TR dash bezel... please pm me if you have one that you're interested in selling.
Thanks,
Johnny
Hi, I'm looking for a good catalytic converter hanger for my 87 TR... if any of you have one that you're interested in selling please send me a pm with details, thanks
If any of you by chance have one of these that you'd be interested in selling please send me a pm. It would look great on my turbo regal.
Thanks,
Johnny
Hi, I've researched all the boards history on this issue but still need a little help. I'm running an older VDO electric speedometer (with the correct VDO vss) from my ATR dash set up and I'm receiving code 24.
The issue I have with this vs in other topics I've seen is that my speedometer...
Hey everyone. I purchased this from another forum member and have since decided to go another route. It's an Extender Extreme G chip with Anti-theftand it's for use with a Gen 2 MAF Translator. $55 shipped and it's yours. Paypal preffered and I don't charge extra for my fees.
Thanks,
Johnny
I have a dash set up with a few cut wires (posted in General Tech section). I'd like to get ahold of an original install manual to help get everything all squared away and operational.
I'm hoping that somebody has the manual left over from their install that they're no longer using and would...
I like my projects so I picked this up locally off of craigslist with the knowledge it may need a bit of work. I have a few cut ends (8 actually) on the harness coming from the electronic board.
Does anyone hopefully have a pic of the harness when it's laid out and/or have a copy of the original...
I'm wondering if any of you hopefully know where I can find a three wire speed sensor similar to the pic below. I'm hoping that it's something autozone would carry if I can figure out what vehicles use it.
Any help would be greatly appreciated.
Thanks,
Johnny
Hey everyone, I'm on the look for a cut-out bezel in good shape (similar to the pic attached).
If anybody has one that they'd be interested in selling please send me a pm with details.
Thanks,
Johnny
Hey everyone. Does any of you by chance have the part number for this valve... I have a feeling that mine is in need of replacement. My TTA builds excessive pressure in the fuel tank and I have a feeling that this valve may be the culprit from articles that I've read.
Thanks,
Johnny
Hi all, if any of you by chance have either of these that you're interested in possibly parting with please drop me a line with details.
Thanks,
Johnny
I'm putting a new oil cover on a timing cover and in the kit it came with a part that looks like it goes inside the cover on the end of the spring... Is this correct? If so, does it matter which direction the holes are facing or aligned? I've done a bunch of forum searches with no luck and I...
1. Kenne Bell adjustable fpr. Good shape except lower threads arent perfect but looks threadable. I purchased this from another member this way and never installed. Please see pics. SOLD
2. ATR maf pipe. Good shape with a couple very light scratches on the under side. $65 shipped
3. Metco Cowl...