Search results

Just measured 1st wire w / multimeter Magnecor 10mm. very few miles but they sat for a while 1st wire 3.85? continuity should be 0- .05 in ohms correct? Time for new wires?

Driving to an appointment today, I noticed a car ahead pulled over w hazards on. Car pulled out ahead of me and I caught up at a stop sign. As the car pulled out I noticed a "pouch" or something on the trunk held on by the rear spoiler( VW jetta) I honked several times and the car sped up away...

It seems a rodent of some sort has been feasting on my MAF connector, I guess this could explain the SES 34 light. Wires were chewed almost all the way through. Once I fix this I will probably find the MAF is also bad. New one on the way from Caspers. IS it OK to use a 3M red quick splice...

and should it be connected? I am drawing a blank as to what it is

I was going to put in AC Delco r43, but read on here recently that the quality on some have been subpar. Are the NGK UR5 found to be better quality and should the gap remain @.35. What is suggested for my set up?

1st time getting her back on the road, exhaust smelled really rich with a Code 34 ( tapped on MAF no stumble then)and a stumble as temp approached 170. This is all at idle Can you please review my numbers and give me your thoughts AF-06 L8-43-46 Bat-13.7 Int-127-136 BL-122 Mph-0 CLT...

these go in from the passenger compartment after removing the back seat? ( BOLT -IN style tube braces)

Black GN heading "north" on Island Ave. PA tags

Again, great service from Dave. Thanks, got everything in short order as advertised.

Ordered RJC Power Plate from him, it arrived on time and in-tact. thanks Jon

Parts arrived timely and as advertised

Excellent. Fast ship and a good guy too

Anyone with a clue on the thickness of the steel on the body panels? TIA

I am looking for grey DS T-top trim around handle

Recommendations on attacking the rust before prepping for paint. POR15?, filler?