Search results

This post didn't get much attention in the general forum so I thought I'd try here. Here's the original post: Hey guys, I've been troubleshooting a vacuum leak for quite some time now and finally decided to make a custom pressure block off for the intake tract. I pressurized the system to...

Hey guys, I've been troubleshooting a vacuum leak for quite some time now and finally decided to make a custom pressure block off for the intake tract. I pressurized the system to about 15 psi, sprayed soapy water around the engine and found leaks at the vacuum block, at a vacuum line, and at...

I still have the stock oil filler tube and a make shift vent on the passenger side as I have deleted the connection from the turbo. What is the best vent/seal for the stock valve covers on both passenger and driver side? Both of these areas leak and I would like to fix that issue. So What...

Sometimes I hear what I think is pinging but my scanmaster doesn't show any timing pulled. Is this possible? The knock sensor is new. Thanks.

Looking for a stock transmission pan, let me know.

I don't understand when to add or subtract timing with my tune. When should I add timing or subtract timing with my scanmaster? I have my overall and 1st gear fuel parameter pretty well set, thanks.

I don't understand when to add or subtract timing with my tune. When should I add timing or subtract timing with my scanmaster? I have my overall and 1st gear fuel parameter pretty well set, thanks.

Looking for a single shot exhaust, I like rjc's 4 inch one, something similar or 3 inch, let me know what you have. Thanks

What percent of e85 can i throw in with 92 or 93to get an octane boost, or can I..

How many miles to break new rings in before I start to really boost it? Thanks

I just got rjc's 3" dp, does anyone wrap these with heat wrap? I wouldn't think it would affect the a/c plastic but it came to mind.

What part is this wheres it go???

The O-Ring between the oil pump and the filter "housing" or the circle metal piece which bolts to the oil pump which the filter screws to. Anybody have an idea??? It's probably about 2" to 2.25" diameter. Please let me know if you have info, can't seem to find one.

Question on my turbo. I have it off and was cleaning it up a bit, the compressor side says A/R .60 and the exhaust side says A/R .63. Is this the stock size measurment? For some reason I thought it wasn't.

When I first took my cam sensor out, I marked TDC with a sharpie on the top of the cam sensor (the part that spins to the stationary part on the sensor. I also marked the bolt where the sensor mounts). Now putting it back in as Im putting the engine together, I can't get the top of the cam...

Parts I could use, thanks.

Are the fel pro head gaskets good quality? Mostly stock car possibly 11 or 12's someday. Thanks.

Need all new engine gaskets seals for motor. Is Fullthrottle's the best to go with? I looked through the list that they have and I didn't see some that I need.. -There is a 0-ring on the other side of where the oil filter screws to ( filter housing? ) by the oil pump about 2" in diameter...

Just wondering, what is safe...

Long story short, my engine is out and I am replacing bearings. Question: Is it a mistake to put my stock turbo back on the new motor or should I think about a rebuild or different turbo.. The turbine shaft has no play and turbo appears good. Motor has 60,000 miles. I would hate to have...