Search results

I thought I checked my pushrod length when I built my motor, but not sure if I did it, right . I have been driving my car for a while, and nothing has broken. Would it be too late now to check the pushrod length again or cents, nothing has broken. Should I leave it alone?

Looking for some different types of valve covers for my 87 GN .

I have tried plastigage and the feeler gage method with out a gasket and with a gasket . I am feet different readings every time . It’s driving me crazy . My motor is installed in the car had a oil leak so took the adapter apart to replace the gasket . . Do you need to take the reading on the...

It says the grove should be a 1/4 deep that seems a lot this is mine it’s just a little less then a 1/4 . Does it have to be a 1/4 anyone ? Will it cut through at a 1/4 ?

What is the torque for the 6 oil filter adapter bolts? Thought I saw it was in inch pds? .

Thought there was someone on the forums selling them not sure who ?

I am trying to figure out if the GNX type center cap fits a 3 inch hole ? I have a set of Riken wheels and want to but buy some new caps . Have seen some that had what looked like a GNX type cap on them but not sure the center hole on mine is 3 inches .

Looking for 2 Riken mesh wheels 16 x 8 or 16 x8.5 .

I bought a set of Riken 16x9.5 wheels and am looking for a 255/50/16 for the rear of my car but these are hard to find does anyone know where to buy these ? I see B.F Goodrich makes one but not anyone else .

I have some Riken wheels that are 9.5 and right now have 255/50/16 on them. I was thinking of running that size in the rear and running a 245/50/16 on the front just not sure if that tire is to small for a 9.5 wheel? So wanted to see if anyone else has run this tire on a rim this wide or will...

I am looking at a set of riken mesh wheels for my 87GN. They are 16 x 9.5 with 4 3/4 back spacing. Just not sure this will fit the front with out hitting ? Not sure about the offset . The front rim has a 255/50/16 on it and the back has 315/40/16. Just need so help on this before ,I drive 3 hrs...

Looking for a impact strip that bolts to the front bumper of a grand national. Looking for one that has no hits that's not damaged .

Can anyone tell what other cars used the same clips that holds the dash bezel on missing some but sure what other cars used them?

Just wondering if anyone has taken the clear coat of and polished their wheels?

Anyone have a dash clips that hold the bezel on? Need 2.

Lost some and am looking to buy some if anyone has any spares please let me know thanks.

Looking for ideas on were to mount the green light and low level red light. Have them below the steering column right now just want to see were others have mounted them can't see the good were they are now so anyone?

Have after market GNX dash and was just wondering were other guys with this dash installed the green light and red low level light? Right now mine are installed under the steering column but want to put them some were its easier to see them so just wanted to see what others have done thanks.

My alky pump was running with the key on figured it out and unplugged it but it sprayed the whole tank in it was not methanol it was denatured alcohol checked the oil level did not go up after car sat for 20 mins and oil did not smell like alcohol so did not change it good oil pressure did ,I...

Installed Art Carr deep pan put a 700 filter in it now the dip stick is hitting the filter has anyone had this problem? Read about doing this swap never read about this problem need help is the different filters to us to not have this problem?