Search results

Lightly used PBM Hydraulic Roller Lifters about 2000 miles or less. Asking $250 plus 20 shipping.

I have an 87 T-top GN what are the best lift points to remove the body off of the frame and other than the steering linkage and body mount bolts are there any other fasteners or parts holding the body to the frame? I should mention that I have a 10 ton over head bridge crane to do the lifting with.

Looking for a good fuel sending unit hanger assembly for a digital dash car.

Looking for a solid G-body in the dallas fort worth area. engine or no engine doesn't matter. something with a solid frame and body.

Has anyone used Leak Lock from Highside Chemicals on their head bolts to seal them in the water jacket? I use this stuff regularly in the electric motor and generator industry. Seems to work well on fluids. The rep says it can be used with antifreeze and its rated up to 400 degrees F. Or anybody...

Does anyone know off hand what the thread pitch is on the knock sensor? Need to grab a tap to clean the hole in the block.

If my cylinders are bored .040 over stock then what size bore should my new head gaskets be?

Does anybody have information on what the main bearing journal and rod bearing journal sizes should be on a stock 87 crank?

I'm pulling my engine and trans out to clean up some leaks and replace the fuel and brake lines as well and was thinking if it's not too hard taking the body off the frame and getting some rust repair work done to it as well. Is there anyone in the Garland/Dallas area that has experience with...

Does anyone know of any good kits for braided fuel, brake and transmission lines?

I have a maf translator with an LS1 maf, whenever I hook it up the ecm starts throwing a code 34 low maf reading but the ecm doesn't throw a code when the stock maf is installed, the gps reading is the same with both maf sensors, anyone have this type of problem before? Also I sent the...

I just recently finished the break in period of my rebuild and I've noticed that when I let off the accelerator after high boost about 15-20 PSI I can hear a fluttering sound that seems like it's coming from the turbo. What I want to know is if a blow off valve would correct this and prevent...

Does anyone know of any reputable speed shops in north east Ohio? Also are there any other gn owners around here?

Can you use the stock pop up spring on a fiberglass hood or is there too much tension in the stock spring?

I just got my new chip today and I finally get everything put together and I start it up and let it run for about twenty minutes and I notice it's running hot. Checked the upper radiator hose and it is hot as well so doesn't seem that the thermostat is stuck closed. The water pump like...

I'm looking for some 87 grand national seat covers

I got a water temp gauge I need to install, the sending unit for the signal wire that came with it is too small for the intake would I be able to tap into the wire of the existing temp sensor and get the correct signal?

Having trouble gettin my gn to run. It'll start for about 3-4 seconds then cuts off. It's not misfiring and the timing seems to be in sync, It has an LS1 maf sensor with translator, could that be causing the injectors to shut off if something isn't right with it? Not receiving any trouble codes...

I'm receiving a trouble code 23 on turbolink which is the MAT sensor it's saying that it is open , I tested the sensor and it's functioning properly when cold and hot any ideas? Also would this malfunction cause the computer to shut the fuel down? Also I'm using an LS1 MAF with translator.

Is there any type of safety switch connected to the shift linkage that would prevent the vehicle from starting if the linkage is not connected to the transmission?