Search results

Sold the car i was going to use these in. Speed pro forged pistons .040 over. Brand new in box and eeight matched. Also have high end rings to go with it. Double plasma moly ductile iron rings. 275 for pistons shipped to lower 48 states. 50 more for rings. All brand new. Pistons are L2481F...

So i just installed a new motor in my 86 t type. Breaking in and after 20 min of break in idling, my knock gauge started to show counts... green yellow then red. A couple of times. So i shut the engine off. Anyone seen this before? Bad sensor? Bad gauge? Problem with the engine? Thank you for...

I do still need it. How much shipped to 84123

Hello. Im looking for the power steering line thats shaped like a C and goes arround the PS pump from a 86 to 87 gn. I know kirban and G body parts sell a stainless one, but im happy with a good stock piece. Thank you.

Unfortunately its not the rag joint that's bad on mine. the shaft does not compress or decompress anymore. its seized

Still looking for a steering shaft. Whose got one for me? thanks!

I am looking to buy a good used steering shaft (part that goes from the end of the steering column at the firewall to the steering gear) mine is rusted badly,. I need one that compresses and extends freely. or the Jeep upgraded one ive heard about. thank you

I have been trying to register too. Tried a few times. will you please add me over?

Anyone know the Administrator on Syty.net (Typhoon syclone forums) ? I have registered two email addresses and cant post anything. He never responds to any emails and deletes my account. Just wondering if anyone knows what the deal is. Thanks!

Can you PM me some pics of the carillo rods and your concerns about them please?

The intercooler is a little more than I wanted to spend. Do you have a blue trunk lid?

I would be interested in both. I live Utah zip is 84123 what are you looking to get out of them?

Interested in 12F. Will PM

I will take them. But are you okay with waiting till next week?

I am looking for good shape blue visors for t top 87 T type, also the plastic interior trim on the t top itself on the drivers side, Drivers side a pillar plastic trim, clean no rust trunk lid, and lower cost front mount intercooler. Thank you!

The cam sensor is not 180 out. I can spin it all the way around and the light is on constant. if I unpin the middle pin in the plug (which is signal to cci module) then it will go out. and then when I spin it, the led will go off and then on like its supposed to. Something is back feeding and...

Ive recently saved a 87 turbo T, which runs, but runs poorly, stalls, and is bone stock. Started verifying cam timing with caspers cap which stays on the whole time. Unless I unplug the cci module, then I can dial it in, Swapped cci modile with one off my excellent running 86 t type, no...

So I have an 86 T type with the electronic climate controls. Where my normal resistor pack would be in the air box under the hood, I have a logic board with a transistor, reisistor, one coil and capacitor. Needless to say its messed up. from water and such being on it for a long time. Has anyone...

So, I got back to my car this sunday. Started it up, Ran Like sh#t, Visually inspected the crank pulley. everything looked fine. seemed tight. pulled the aluminum cover off, and looked inside........... The bolt was a third of an inch out of the crank pulley.... and the reluctor ring was not in...

Thank you all for taking the time to reply. On my other 87 gn the cam sensor blinks so you can see it until higher rpm. But maybe its just that car.I will check the plug behind the glove box for sure. the cables are new and in good shape. Crank thrust is a good point. I will have to look at that...