Search results

OK Guys, what's it worth? 16K mile running gear...Basically Complete from Intercooler to Rear end. Stock everything, I'd have to double check but may have adj. FPR on it. Took out of the car, about 6 months ago, drove it to the shop to pull it all out. I've gotten some hits on selling the rear...

I have had this combo for a while now and we just swapped everything over to another car. Went to check timing with adjustable timing light and it's not reading correct. Verified TDC WITH A piston stop and the balancer is correct. In order for the timing light and balancer to read correct is to...

I have had this combo for a while now and we just swapped everything over to another car. Went to check timing with adjustable timing light and it's not reading correct. Verified TDC WITH A piston stop and the balancer is correct. In order for the timing light and balancer to read correct is to...

The time has come for a trans after 3 or 4 rebuilds this one is toast. I am looking for something that will handle 700+ftlbs, still retain lock up, and fully automatic shifting. More than likely going to put a brake in this one as well. SOOO vendors fellow tb'ers, sell me one, tell me who or...

woke up this morning cranked the car and let run for 2 min, backed out of driveway(steep uphill) and pulled in front of the house. still running i ran inside for about 2 min came back out put in drive and nothing, pulled down to 1st barely moved slipping like crazy. checked tv cable still...

what af do you guys aim for during cruising down the interstate, i like to keep it around 13.5 but am i leaving some mpg on the table with this setup, and am i not cleaning the plugs enough

i installed a stand alone harness on the car and i am getting around to wiring the ac. i replaced dryer, compressor, orfice tube, because it had been sitting for a while and compressor locked up. i replaced high pressure switch as well. Here is the problem, before i take it to the shop to...

What do you guys usually look for on these cars, I am used to turbo mustang like to keep it rich. I am trying to keep it conservative on pump gas. Short version: 109 block, nice set of iron non egr, mild cam, 64mm compressor wheel, all the other doo dads

i installed a FAST on car so i am hard wiring the tcc solenoid. i have power going to A the tcc solenoid(just pulled pan off to verify) if i ground D the solenoid clicks but seems weak but i have never checked another one, while driving on the interstate i would ground the tan/black D wire and...

Hey guys, I know no one likes doing this or seeing this post; but i'm having issues cranking the car today and was looking for some help with a startup file/tune. Any help would be greatly appreciated. Car has 55s, t-66, ported stock heads, intake, etc. Just wanna get this thing running...

I have a Gen1 Big Stuff3 SEFI set up for WBO2, with a Brand new Plug-n-Play adapter Harness (from Precision) for sale. No Wideband is included. Ended up going to a Fast Classic. Looking for $900.00 shipped Thanks Hunter

i am installing a classic along with the harness and need to figure out what all to keep out of the stock wiring, really just need a visable diagram of the bulkhead below the wiper motor to make sure i get all the ac and wiper etc etc wires back where the need to be and proper signal and power...

Hey Guys, i've searched and haven't been able to put my finger on an answer. On friday i recieved my Classic Fast Ignition Adapter Harness (for Buick) that I ordered from Hartline; I am having problems figuring out what the yellow wire (from the CCCI connector) goes to? The pin-out I have...

I have a Gen1 Big Stuff3 SEFI set up for WBO2, with a Brand new Plug-n-Play adapter Harness (from Precision) for sale. No Wideband is included. Ended up going to a Fast Classic, couldn't pass up the deal. Looking to get $1200 + shipping for the package. Will try to get pics up later...

Hey guys, I am trying to find some help with running down a Start Up Program for a Big Stuff Gen 1 ECU. I bought it second hand and it was being used on a V8 car, so I've got it in and am looking for a Base Map to get the car running. The Specs are TE-64 Turbo, 55 lb injectors, Ported...

Hey Guys, I am in need of some help... As soon as you start the car, it is rich as crap. Barely wants to run (will keep itself going, but it's not pretty). Here are the details; I just put a new dash harness and engine wiring harness in the car. I have a brand new O2 Sensor, Two...