Search results

  1. J

    10 vane or not

    Never ran a pressure check. Had this installed for a few thousand miles around 12 years.
  2. J

    10 vane or not

    So it looks like the pump cavity might be damaged. What have I got here?
  3. J

    10 vane or not

    So as my luck goes I always tend to brake things when driving like a grandma on the way to church. Here is what I was told my transmission has installed: billet drum fully rollerized gear train front pump and output shaft customer servo trans brake, stage right 555 and 405 boost valves rev kit...
  4. J

    Does a sway bar out of a 2002 TA fit the GN?

    I would have to say no it would not fit Different body altogether.
  5. J

    600 Steering gear boxes Available !!

    I have mine installed already, love it. I have gone through 3-4 rebuilt boxes from O Reilly, Auto-zone, and NAPA, all of the was sloppy. Stepped up and bought this box and wow what a difference, I opted for the bare finish, wish I would have had it coated now. Very simple straight forward...
  6. J

    Finished steering upgrade

    Every where I look it shows the Lee box is discontinued. Does the Turn One use different hoses?
  7. J

    New guy St Louis area

    That is definitely an uphill battle. Your best bet might be to find a donor turbo regal to start the parts swap over. http://www.gnttype.org/ is a good place to start looking at the basics on a LC2 engine.
  8. J

    Any Helpful Tips, Im installing a FMIC RJC 315IC

    I used dish wash soap, real slick while wet then very sticky when dry WD40 might make it easy to slip off under boost, be careful about the hose clamps.
  9. J

    Wiring issues

    I feel your pain. I have been working on a nightmare wire harness issues. I slowly traced a bunch of wires and then cut them out and threw them on the garage floor, when I was done it was crazy how much i removed.
  10. J

    Digitalis Cannot Get Turn and Running together

    Thanks for that link. I ran the black to ground and now everything is awesome. I love this board.
  11. J

    Digitalis Cannot Get Turn and Running together

    I did not have that set of instructions, must have been after I got mine. I wi
  12. J

    NVU gauge cluster installation.

    I love the GPS accuracy. It was easy to install only left now is wire the ECM to the trans sensor.
  13. J

    NVU gauge cluster installation.

    I owe you w cold beer. I had mine hooked to other one. Just swapped it and presto I now have indicated oil pressure. So happy right now. Thanks.
  14. J

    NVU gauge cluster installation.

    Mine has two posts in the oil sender. Didn't the direction say that it had to be grounded? Yes my fuel needle bounces when turning, stopping, and vigorously accelerating
  15. J

    Digitalis Cannot Get Turn and Running together

    I have the digitails that I still cannot figure out. When the running lights are off everything seems to work perfect. As soon as I turn running light on both turn signal indicators light up but tail light are dim like they are supposed to be. Running light off and turn signal on it works but...
  16. J

    NVU gauge cluster installation.

    I am still working the bugs outta mine, no oil pressure at the gauge right now.
  17. J

    Re-using RJC gasket after leak

    If Jason wont sell you just one then buy a pair and list the other one on here. I would not use anything other than a new RJC gasket.
  18. J

    Steering Box Removal Procedure?

    Pretty straight forward. The hardest parts is getting the drive shaft off the box inlet. I pried and beat mine off.
  19. J

    What did you do to your GN today?

    Started my NVU gauge installation that I have put off since early spring. This is the hardest project I have done in a long time.
  20. J

    LED tailights GNS/SPAGHETTI

    I did buy mine from Scott in the initial group purchase. I am having issues with the left side. Does not flash at all when tail lights are on. I was going over the direction posted on GNS website and looks like they have changed the boards around a little. I will have to contact them I guess...
Top