Search results

  1. Reggie West

    Burned up 2 E85 pumps

    Did you get your pump issue solved? If not talk to Joe Telesca on here. He makes a billet hanger with a DW400 pump. Comes with new wiring from the alternator back, sending unit and it drops right in. I am running it with a 70 mm turbo. It will work just fine for 62 as well.
  2. Reggie West

    Classic FAST no start issue

    Thank you Norbs.
  3. Reggie West

    Brown or tan wire with black stripe.

    Thank you for the help.
  4. Reggie West

    Brown or tan wire with black stripe.

    And where does the other end go? Fuse panel?
  5. Reggie West

    Brown or tan wire with black stripe.

    Where does it go?
  6. Reggie West

    Classic FAST no start issue

    All other wires are good. Checked that. TPS is good and working. Not sure at what percentage exactly, mu guess is 40 to 50 %
  7. Reggie West

    Classic FAST no start issue

    GN has a Classic FAST on it. Wideband 02 went out on it and replaced it. Put it back in and now the car will not start at all. The only way I can get it to start and run is by gas pedal at 50% or so and cranking it. Then it starts right up and will idle like its normal self. This is...
  8. Reggie West

    Engine Rebuild for a Newbie

    If you are going to use that 55/58 turbo you can get away with stock crank and rods and go forged pistons. Ported and polished heads are a good idea. Studs clamp a little better than bolts will. The front cover can be blueprinted and high volume gears put in it. You dont need to girdle the...
  9. Reggie West

    What trans 1K RWHP. Not 200 or 400

    Keep in mind I was told that the rpm is the deciding factor between a 200 and 4L80. The Stage motor will rev up to 8000 rpm and that kind of rpm causes the clutches to self apply. A 200 would work IF the same power is being made under 6000 rpm so I am told. Make no mistake there is a...
  10. Reggie West

    What trans 1K RWHP. Not 200 or 400

    I was just speaking with Len Freeman about a 4L80 behind a Stage 2 head motor making 1250 hp. He says it would work just fine. His quote was less than $6000. Much less.
  11. Reggie West

    Under Dash Support Brace..."Stop the Sag"

    Sold. IM me so I can send you money. Thx.
  12. Reggie West

    Under Dash Support Brace..."Stop the Sag"

    Coach do you have these available?
  13. Reggie West

    Need to install CA legal exhaust system

    Unless your car is bone stock it won't pass a CA emissions test. If you have the stock chip that helps a lot too. Turbotweak does make a smog chip that will help you with that if you need it. It is well worth the $80 if you don't have it. You will need the catalytic converter, the EGR needs...
  14. Reggie West

    Finally got the engine out, what's recommended?

    If you pull the heads you will need to get head bolts. ARP still makes them. You can go with studs but its overkill for your motor. Stock replacement Felpro 1000s work just fine for head gaskets. I will bet the block still has a rope rear main seal in it. Replace it with a neoprene one...
  15. Reggie West

    DYNO results in!

    23 psi is still low in terms of boost. There is more left in the turbo. Any of the 60 variants wont max out until 29 to 30 psi. Time to port and polish the heads and check your springs. A cam change would help too. 210/210 hyd roller nothing too wild. A converter would help but you can push...
  16. Reggie West

    4.3L Vortec Block Limits

    You need to look at Dan Jost and what he has done with a LV3 motor. Look him up on FB.
  17. Reggie West

    WANTED precision turbo pt5558

    Why not go with a Comp 58/58?
  18. Reggie West

    New DW 400 Fuel Pump!

    I gave them Joe's number so they can talk to him.
  19. Reggie West

    New DW 400 Fuel Pump!

    Nice job with the trunk access to the pump.
Top