Recent content by vl1500

  1. V

    Where in Tn. are you located?

    Where in Tn. are you located?
  2. V

    Need help!!!!!

    Hi guys, while installing my rings I broke one! I need the second ring from a Sealed Power "E434K Std" kit.
  3. V

    Best rod/main bearing

    Thanks!
  4. V

    Best rod/main bearing

    Which rod/main bearing to use for a stock rebuild with upgrades for 11.30 times slips?
  5. V

    Syclone service manuals

    Syclone Manuals 100.00 plus shipping.
  6. V

    Syclone service manuals

    I have a complete set of Syclone service manuals for sale. These manuals were purchased through the dealer and are in great shape. Accepting offers!
  7. V

    Difference between 86/86 pistons

    difference between 86/87 pistons The two original pistons and 4ea stock pistons that I purchased had the same crack around the wrist pin area thus indicating that something is not right.Maybe it could be the way the pins were pressed on and off or maybe a cast defect or even detonation however...
  8. V

    Difference between 86/86 pistons

    difference between 86/87 pistons I was told that the 86 TR pistons were not as strong as the 87 TR pistons and that they had different part numbers.I tore down my engine and did not have any cylinder wall wear but two of my pistons had a crack in them were the wrist pin goes. Have you seen this...
  9. V

    Difference between 86/86 pistons

    Does anyone know the difference between an 86/87 TR piston?
  10. V

    Cracked Piston

    Thanks for the response but that is not the location that I am referring too.Looking under the piston there are two holes on each side of it were the wrist pins are pressed in.The small hole on the top(looking inside the piston has the crack in it,like I said earlier two of mine had it and four...
  11. V

    Cracked Piston

    Hi guys, I am rebuilding my stock 109 engine and the machinest found two pistons with a crack going towards the inside of the piston where the wrist pins are pressed in.There is a little hole on the top of the pistons on both sides and one side has a very thin crack in the same place on both...
  12. V

    Bison, I am rebuilding my motor using the stock pistons with studs and ARP rod bolts.My plan is...

    Bison, I am rebuilding my motor using the stock pistons with studs and ARP rod bolts.My plan is for a daily driver but it will see some track time,I would like to rua low 11's but not sure on which head gasket to use,on my past rebuilds I used the stock GM head gaskets.Any help would be...
  13. V

    WTB Stock Pistons

    WTB Pistons Thanks for the responce guys,I originally ordered 2ea from gbodyparts that had the same problem that mine had,I talked to Eric and he is sending me two more,once again thanks and God bless.
  14. V

    WTB Stock Pistons

    Looking for stock low milage pistons for 86 109 std bore block,need pistns only!
  15. V

    Fuel Pump and Injectors for sale

    I will try to post pictures tonight or tomorrow(working late)however I will get all the numbers off the pump. I used one of these pumps in the past and it worked very well also this is the type of set up the Lawrence Conley used.
Top