Recent content by tyson

I'm looking for a rebuild kit for a camshaft sensor. Can you email responses to tshort@climate-engr.com let me know price and how to pay you. Thank you,Tyson

TurboBuRick your asshole attitude is why I barely get on this board anymore if you don't want to help don't comment

Dank, no i just did the 1.45" so it's at the 25 degrees is what I was saying. I do have fuel pressure. I took voltage readings at the injector pigtail/plug last night. I'm only pulling .75-1 volt. Obviously way low. So if the injectors ground through my ecm, what ground off the ecm do I need to...

Thank you

Sorry been busy haven’t had a chance to get in here. I replaced the crank sensor with an ac delco. Yes it’s in the correct slot. Same issue, won’t start. I think i have figured out what’s up. When the noid light flashes it is really dim. It should be pretty bright I’m. Guessing. So I’m guessing...

I used the instructions with the tool. Brought it to tdc marked the 1.45"/25* after tdc. Rotated motor to 25* after then Aimed window of cam sensor somewhat towards drivers headlight. Put cap on connected to tool. Turned clockwise until light shut off, turned it back until light just turned on...

Just built a new motor for my 87. It's got good fuel pressure at the rail(40lbs or so) gets spark. Checked injectors pigtail with noid light, all are working. Did the camshaft sensor setting with Casper tool twice. Has a new crank sensor set at about .025 gap. When I first try to start it it...

Thanks for the info. I'm building a motor and don't have one at all. But that info will help with my search.

I need a timing chain cover for a 84 GN. Message me through this sight or email at tyeshort92@gmail.com Thanks, Tyson

Location?

How much for std crank shipped to robins ia 52328? Thanks Tyson

It was more of the tail pipe. I think I got it fixed. It's raining so I can't take it for spin right now. I did find another small vacuum leak but I think the big problem was me over looking what should have been obvious. The car has been an on again off again project for about 4 years now. I'm...

I have a (used)later model 3" maf with a translator also.

I have an 87 gn. 55k miles on motor. 6031 turbo(new) 80lbs injectors and TT chip(new) for e 85. 62MM TB and plenum. 204/214 cam(new) 3" THDP(I think) front mount off a powerstroke. G bodyparts crossover pipe, poston Pass. header(stock drivers). adjustable fuel reg. 340 walbro hot wired. I'm...

I need the small piece of trim that goes on the top corner of the a pillar on a t top car, drivers side. It has a 30* bend and is about 3" long total. This sits atop the longer a pillar trim that runs up/over the rain gutter. Thanks, Tyson