Recent content by T62TTA

http://www.turbobuick.com/forums/south-western-area/315530-89-tta-sale.html

This is the short block engine details of the car http://www.turbobuick.com/forums/turbo-trans-am-tech/221875-tta-shortblock-fs.html?referrerid=13967 However, Razor installed a complete roller cam kit before assembling the long block together. This engine has the Comp Cam full roller kit with...

$8500 I have well over 25k invested in parts. Heres the link to the short block http://www.turbobuick.com/forums/turbo-trans-am-tech/221875-tta-shortblock-fs.html?referrerid=13967 this was purchased from user name Razor. This is the same short block that put his car in the 10.5 sec pass, same...

1989 Turbo T/A 101k miles. Heavily Modded with Champion Ported Heads 212/212 Roller Cam 1.7 Scorpion Roller Champion Ported Intake. Engine bought and shipped from Julio Don of Alcycontrol.com CK Performance 200 4r Transmission stage 2 build fully rollarized internals. Currie 9" Ford Rear End...

More pictures Front and side view, casting number shown.

98k miles and running when pulled. Intake manifold and valve covers included. Add your own oil pan and timing chain cover. Local pickup only. $800 323-395-4926

You need the magencore plug wires for TTA Contact Jack from Jack Cotton Performance. He carries a set of TTA plug wires specifically for the ATR downpipe. Thats where I had to order my set from.

Does it Fit a TTA? Would this work for a TTA?

Its The Vats Samething happen to me. You need to buy a new ignition switch from GM with a new key with pellet. I bet you anything its that. What I did to mickey mouse it for the meantime was measure the resistance of the pellet on your key and buy a radio shack resister and just plug that in...

cold air kit giveaway Count me in

383 stroker Small Block Chevy is completely build from the ground up. No corners have been cut. The engine is FRESH. Only has dyno time and I could provide a dyno sheet. Was ready to go into my 87 GTA but because I want to re-build my 89TTA I'm willing to part it with one of equivalent build...

Smoke does come out the breather on initial cold start I do get smoke coming out the breather, only temporarily when on an initial cold startup. It looks like steam is coming out the breather until it warms up. I have monitored my coolant levels and I have absolutely no lost of coolant. I do...

Well, just completed performing my first cylinder leakdown test. Approximately 2 months ago I did a compression test only and got satisfactory readings in the 150-155psi readings. Anyways these are the results using the dual gauge Proform leakdown tester: Cylinder 1: 35%leakdown Cylinder...

Takeoff units that I bought off of someone else that were new in Kenne Bell Mustang kits. These are Lucas Injectors. Complete set for $215shipped.

Translator plus and extender chip LS1 MAF All the BLM between 125-130 Car had set a code 42 so I reset the computer and its gone Casper Knock gauge on pillar begins lighting up as early as 6 psi and my EGT seem to have gone up everywhere while I drive. Settings are extremely conservative...