I currently have a smc alky kit (1 nozzle) found out today the pump is leaking pretty bad on the bottom seal. Would I be able to purchase your pump and run it with the smc system or do I have to switch over to razor completely
I have an UGLY Charcoal backround with yellow members letters and dark gray messages that I can't read any longer. Getting up there in age and I need a better color combinations on the site. Have emailed a couple of guys like Nick but have never received a reply, that's why I don't come here much any longer. CAN"T READ the darn threads.
I was looking to replace my Alchy Control Nozzle for my TTA and i'm not sure what the part number is or how to get a repacement. I tried ordering this http://www.mcmaster.com/#3178k77/=s3acdp but it looks different. Also looking for the right angle fitting.
As part of preventative maintenance, I ran a leak/pressure test with one of those pressure tests you used to sell (maybe you still do?). Detected a pretty significant leak at the inline filter fittings. Snugged the fittings up and no more leak for now. Looks like the sealant has gotten old and crusty after all these years. I'm going to take it apart and reseal the threads. Looks like you used teflon paste?
I HAVE A X275 GN. I AM GOING E85R NEXT YEAR. I WAS THINKING ABOUT A NOZZLE AT THE COMP HOUSING
AND RUNNING NO INTERCOOLER TO SAVE WEIGHT. JUST LOOKING FOR AIR CHARGE COOLING DO YOU
THINK THIS WILL WORK AT HIGH BOOST.ILL ZAHER
Hi Razor, am installing one of your older Alky Control units n a friend's GN who is color blind. The on light turning red to green cannot be detected by him. How do I wire two LEDs into the circuit for two individual lights into the twisted brown and orange wires. Any help would be appreciated. Loyd Bonecutter
I did get the pump hooked up and everything works. Does you pump put out more volume or pressure? It about emptied my tank in a few short runs and was also rich. Should I change to smaller jets on my dual spray? If so, what size? Do you have any? Thanks
I got an external replacement pump for my SMC kit. The two white wires on the SMC go into the tank to what looks like a low level warning. Do I splice your two white wires into those running from the tank or are they for something different?