Recent content by racer5252

  1. R

    Buying alcohol

    Where is everyone buying alcohol. Is there anyplace online?
  2. R

    Stock oil dipstick

    Thank you, I ordered it today
  3. R

    Stock oil dipstick

    Interested, how much shipped?
  4. R

    Stock oil dipstick

    The only thing I see he has is just the actual handle for the dipstick
  5. R

    Stock oil dipstick

    Looking for a stock oil dipstick for 86-87, I have the tube, just need the dipstick or info on what replacement will work.
  6. R

    TV cable

    Did you ever find one that works? I am in need of one now but nobody has them .
  7. R

    1986 TType Driver Side Power Seat switch needed

    I am also looking for a driver side seat switch for an 86 GN but my part # is different (20411769). It is a 7 pin. I want Joe to have first dibs on one since this is his thread.
  8. R

    Wtb passenger quarter panel

    How much end play do you want with the shimmed roller button?
  9. R

    Flat tappet cam failure

    Do you have the name of the machine shop?
  10. R

    Flat tappet cam failure

    That is exactly what I needed to hear, with that being said do you have any suggestions on a machine shop in Northwest Ohio or southern Michigan?
  11. R

    Flat tappet cam failure

    I just got my new billet main caps so I’m ready to take the block and crank to the machine shop. You mentioned that by the looks of the thrust bearing that the crank thrust could also be damaged, is there a way to check it? Also I want to verify that the bearing clearance for the rods and mains...
  12. R

    Flat tappet cam failure

    Well I guess worst case I’ll have to buy new .020 under bearings. I measured them without polishing and thought I should be fine with .010 under. My thinking was why pay to have someone polish it just to turn around and turn it down. We’ll see, I’m still learning. Is 3/8” hole the biggest I...
  13. R

    Flat tappet cam failure

    Should I try and chamfer the backside of the bearing?
  14. R

    Flat tappet cam failure

    I just ordered new .010 under King bearings for the crank and rods. I’m going to shoot for .0015 to .002 . I’m new at this so all this info is great. Now I have to find a machine shop that can do it.
  15. R

    Flat tappet cam failure

    It definitely could have been a bad tune.I do run a stock transmission with a 2800 stall converter
Top