I am. I haven't been actively looking since the car is sitting since all my transmission issues. But yes I still do need one . I have just about every billetpart CK performance makes for a 2004r and I've had the trans apart 3 times now and it still isn't right. This time I want to use a new...
I really just need a good case but a hole core would be fine also. I'm in Lancaster Pa. If there is anyone close with one they don't need please PM me.
Thanks
I have no idea what this is worth. It was on my 87 GN when I bought it. It's a steel pulley and I have the belt that was with it. I sand blasted it and was going to powder coat it but I'm never going to use it $50 OBO
I have a PTE 5831 turbo I bought a few years ago from gbodyparts. I put about 300 miles on it and I blew my motor. Just as a precaution I sent it back to gbodyparts and they went through the hole turbo to make sure it was ok. I haven't installed it since.
Asking $600 obo
I did figure out the problem after working on it in 30 minute increments a few times a week for months. It was a silicone intake elbow that connects my air filter that was collapsing over 5000rpm. The strange part its the same intake pipe I've used for years with my old setup. My new 6265 turbo...
2 of the 3 I tried came from running stock motors. Although my motor isn't stock anymore. What kind of HP will the stock modules support? I even tested them with a caspers module tester