I am in need of the black 27 tooth speedometer driven gear. The one that the Speedo cable slides into on the transmission. Mine is worn and my needle was erratic. I was able to find a 31 tooth white gear to use temporarily, but the speedo appears to read about 5 mph low at 50mph.
Please reply...
ohm results.........
The wires between each sensor ohmed out to .08 each on the 200 scale of my multimeter. I hope the Ignition module splice I ordered from Caspers arrives today or tomorrow.:D
I can ohm them this evening..........
Good Afternoon,
I did do a continuity check from the Harness side of each sensor connector to the Ignition module connector. I hade continuity on all 3 wires for each sensor. I will ohm the wires this evening when I get home and post the results.
Thanks:)
With the information you guys gave me, I am 99.9% I found my problem. It appears that my CCCI connector is bad. Once i had confirmation that the ignition module powered the crank and cam sensors thru pin P I proceeded to bench test my ignition module by applying 12 volts to pin P and measuring...
Hello All,
I have been trying to trace down a no spark, no injector pulse issue. I have traced it down to the fact that with the key on, I am not getting a voltage to either the crank sensor or the cam sensor. I do have battery voltage at pin M and P of the ignition module.connector. Where...
I have been looking for a good under dash wiring harness schematic. That one on Gnttype.org is just too small to read. Does anyone have a good source for all the detailed wiring harness schematics with circuit number and wire color?
Gbodys filler project
Quote from Brian at GBody,
"When ours get done we are hoping to have the closest appearing filler to factory as possible.
We are not rushing this & plan on presenting a quality control that can fit on every car & look factory when installed. Do I have an exact date no I...
I set up my oil pump to tight and siezed it. :frown: It sheared the pin on the cam sensor gear, Where can I get another hardened roll pin for it?
Thanks,
Lorenzo
http://www.turbobuick.com/forums/general-turbo-buick-tech/353448-ignition-module.html
Check out this thread esp. post #16 from GNVenom, he makes tester for the coil and ignition module.
HTH
Lorenzo
Check with Jstahl,
My module went out monday and I am buying one plus coil pack from him. He test them before he ships them. Might want to PM him and ask him if he will check yours. What brand module and coil do you have?
HTH
Lorenzo
USMC
1991-2001
1341 Heavy Equipment Mechanic (first 6)
lat moved to
2141 Amphibious Assault Vehicle Mechanic (last 4)
Thanks to all who served and those who are serving now:)
Ditto with Roger,
I always thought in the engine compartment was never a good place for the translator. I have had their since the second week I got.
HTH
Lorenzo
Hello,
G-body parts is doing a mold of the fillers. I believe these will be fiberglass.
The big rumor is Richard Clark is also doing the fillers. These are (don't Quote Me on this;)) supposed to be made out of a flexible Urethane type material that won't break down over time like the...