Recent content by Morden

I have ordered from them a few times and they have always done what the said. Also very helpful.

Does any vendor make a 2-piece valvecover? Would be great to just lift the lid off and check the valvetrain, Pulling the entire valvecover off just sucks.

Thanks

Would like the 1 86-87 Throttle Body Freshly rebuilt, ported and polished by Steve Monroe at Throttlebodys.comto 62mm (cost $185) $150 w/no core charge Does it come with the gasket.

I would like to remove the translator Plus from my Buick. I need to know if I can just make a jumper to plugin where the timing from the translator connected to the module so that the ecm would be back in control of the timing. If not then what would I need to do? Thanks I tried the search but...

@sams86gn Steve told me about this thread. I have black carpet from ACC that I do not need.

Do you have a passanger inner fender well for a 87 turbo car? If so please send me pics as I need one that is not cracked in very nice shape. Thanks

Need a GN or Turbo Regal passenger side inner fender well shipped to 29906. Needs to be very nice or new. No cracks and I will need a pic or two of it. Before we have a deal. Thanks

Bob i ordered the chip and injectors along with the powerlogger and Maf gen 2. I was told that i had to have the chip programmed for the gen 2? I had hoped that i could use the translator plus then switch to the gen 2. I will be ordering the tr6 later this week. I also ordered a 050BUICKADAPT is...

Thanks Bob will do.

Thanks Bob Where all can I order the Chip from? I went to Full Throttle speed, But didn't see where I could input the info?

Bob I have decided to buy a New ECM and 80lb injectors along with a New Chip and the TR6. I figure I will sale all of my old stuff.(maybe) I have a few questions. 1. Would it help if I provided you the part number or info from the old Extender Extreme chip sheet? 2. Can I still have the same...

Thanks Bob for your time.

Thanks I'll wait to hear from you.

Thanks again Bob The AC is off with that number. I will move it down to 20-30 this afternoon. What Brand of injectors would you recommend? Can I myself move the drivers to a New ECM? Or would I need to send it off? Is it just a Chip? If I do need to send it off who would I send it to? Thanks...