Recent content by Martin U

  1. M

    Speedo question!!

    I tried all the above at one point in time,and none of it helped. It wasn't until I got out the Mic's and started checking the nylon gears. I found the speedo gear was warn, but you sure could not tell by looking at it. But a new gear in...all is fine and has been foe a long time now. All the...
  2. M

    Carpet install ?

    I did do that,I just didn't know if I should mount seats on top of carpet. Thank you very much
  3. M

    Carpet install ?

    About three weeks ago I bulled my seats and carpet to install new. Three weeks is about two weeks past my ability to remember anything any more?? This is AFTER making a mental note on things to remember. It also seems that this is about 2 weeks 6 days past my of remembering said mental notes...
  4. M

    hot air wont start

    I found a bad female connector pin on my coil pack connector one time,pulled it back out and it fired right up.
  5. M

    Injector harness help--long

    Thanks again for the help.IT IS ALIVE! I was looking things over with the print out you sent, getting ready to do the testing. i disconnected the pig tail from the coil pack and thought that two of the female looked pushed in to far. C and G or H. After pushing them up some,I cleaned the...
  6. M

    Injector harness help--long

    Thank you so very much. This I think I can do. I just needed a different explanation than what my mind was sputtering on. I did put a new crank sensor in just in case. Could the cam sensor still be off 180deg, I set it with the piston on the up stoke marks aligned. I will not have the chance...
  7. M

    Injector harness help--long

    This is a re-post of a question I asked in the hot air forum,but never got any response. Maybe I asking the wrong question the wrong way I don't know. Any way I'm going to get what info together I can and just start probing some wires and see if I can find something. If you can offer a simple...
  8. M

    Injector harness help--long

    How can i check the connectors to the harness for power,and how do i test the harness it self.
  9. M

    Injector harness help--long

    Hi All, I have a no start condition. I do have spark,and the fuel pump starts and prime as it is supposed to. cam sensor was set using Casper setting tool. I do question weather I am on the compression stroke, I had my finger over the spark plug hole,checking for air escaping. The engine...
  10. M

    Thermostat housing needed

    Thanks, but I have one on the way.
  11. M

    84 Thermostat housing

    Yes. I have one on the way. But if it doesn't work out are you willing to part with just the housing?
  12. M

    Thermostat housing needed

    Folks, As stated, I need a decent (flat) housing for a 84 hot air. I also posted in the parts wanted section also. I thought I would go right to the source. Thanks Mart Urbanski
  13. M

    84 Thermostat housing

    As stated, I need a decent housing for a 84 hot air, Thanks mart Urbanski
  14. M

    WTB..22 Target Pistol ?

    Look up a S & W model 41. Great target pistol, fine machine I've had Rugers and Buckmarks. I shoot the 41 in bullseye competion.
  15. M

    Wiring problem,hookup

    OK thanks. I just have the wires laying out to Figger out what they do. I'll get them all tucked away before I'm done. trying to clean up the wiring is how I got myself into this. Mart
Top