Recent content by lolo86GN

  1. lolo86GN

    PTE SLIC mounting hardware

    Calling Precision would have made too much sense lol.. they had it in stock. thanks for the help!
  2. lolo86GN

    PTE SLIC mounting hardware

    Would anyone happen to have the passenger side side bracket and mounting bolts for the PTE SLIC. I know it's a long shot but crossing my fingers.
  3. lolo86GN

    Can anyone identify these wheels

    The "E" on the center cap identifies these as Epsilon Wheels made in Japan.. Wheel offset is stamped on the rear of the wheel where it says "OFF." wheel width I believe is that JJx10 which would make the wheel pictured 10 inches wide. They are worth good money if you find the right person.
  4. lolo86GN

    CCW D240

    I just gave them my specs. But if you're close to them I'd stop by and have them take measurements. Sent from my SM-G965U using Tapatalk
  5. lolo86GN

    CCW D240

    I did have stock calipers on mine. Not sure on the measurement difference with the c6 calipers. Sent from my SM-G965U using Tapatalk
  6. lolo86GN

    Powermaster System

    Looked Sent from my SM-G965U using Tapatalk
  7. lolo86GN

    Powermaster System

    I remember when driving down the street and pressed the brake pad and had no brakes. If you've been lucky enough to experience that and live then good. Soon as that happened to me I switched to hydroboost. Never liked back! Sent from my SM-G965U using Tapatalk
  8. lolo86GN

    CCW D240

    And just to confirm. The front wheels did end up at 4.50 do to me giving gmr wheels the wrong offset. They had never done a wheel for a grand national before so it was a little bit if trial and error. But they should have the specs on file after doing my wheels. Sent from my SM-G965U using...
  9. lolo86GN

    CCW D240

    Gta's can't hold a candle to the wheels that were on my car. They really made the car stand out. But that's just my opinion. [emoji16] Sent from my SM-G965U using Tapatalk
  10. lolo86GN

    CCW D240

    These are the measurements I used Sent from my SM-G965U using Tapatalk
  11. lolo86GN

    CCW D240

    Remember I didn't end up going with the CCW wheels. the ones I did buy were 2600 just for the wheels. CCW would have been 4k just for the wheels. There is a sticky in this section of the forum where Scott from GNS talks about the offset of the wheels. I believe the offset for front and back was...
  12. lolo86GN

    CCW D240

    No, the insurance covered the loss. To be honest I'd rather have the car than the money. Lot of hard work and time went into getting it to where it was. I still have the itch though so another is in my future next year or whenever a good deal comes along. [emoji16] Sent from my SM-G965U using...
  13. lolo86GN

    CCW D240

    I didn't have to do anything really. I took the measurements from Scott's car from GNS performance when I had my wheels made. Stock suspension and brakes. Unfortunately only got to drive the car for a couple of months before it got stolen. [emoji24] Sent from my SM-G965U using Tapatalk
  14. lolo86GN

    NORFOK AREA SOS!!

    Exact same thing happened to me and it was the crank sensor. There are other areas to check like the ccci fuse under the dash.. there are good discussions on this site addressing what could cause this.. I pasted one below. Google “grand national no start” and you’ll get a bunch of other...
  15. lolo86GN

    CCW D240

    Ok Sent from my SM-G955U using Tapatalk
Top