Recent content by jshot

  1. jshot

    Tach reading hi, TCC not locking up

    Not to sure how they function mechanically. But they are cheap and easy to change. You will need 5-6 litres of fluid. Lots of people are using dexron6 and a filter kit. When removing the filter you will need to remove the old o-ring without damaging the hole
  2. jshot

    Tach reading hi, TCC not locking up

    if you don't have a scanmaster you need one. i like the scanmaster G. compare the scanmaster RPM to the dash RPM. could be just the Dash gauge out of calibration or needs repair. you can test you TCC solenoid by installing switch VIA the ALDL port. you can find that procedure on here as well...
  3. jshot

    Tach reading hi, TCC not locking up

    is the tach reading high or is the RPM actually high ?
  4. jshot

    Tach reading hi, TCC not locking up

    since the intake was removed. check your TV cable settings, while you are at it set your throttle positions sensor and IAC settings. all these procedures can be found on this site or Turbo Regal Web Site. also make sure our vacuum lines were all installed correctly and zip tied. this would not...
  5. jshot

    shiny stuff suspended in the fluid

    i guess the real question is where its coming from. torque converter or trans. being non magnetic its gotta be brass or aluminum.
  6. jshot

    shiny stuff suspended in the fluid

    did a fluid and filter change. 1000 miles since the last one. wanted to inspect the fluid. a little black stuck in the pan and a fine powder on the magnet. but what concerns me is the shiny particles and tiny flakes suspended in the fluid that is not magnetic. have been monitoring and this is...
  7. jshot

    Do I have a problem?

    At what point does the stock turbo become un-efficient. ? Does Larger turbo have less heat transfer to the charged air to allow for gains or is it all about boost ?
  8. jshot

    1'st gear not putting power to the ground

    I should also add I think I heard a "drone" at one time at 1/2 throttle from a stop.
  9. jshot

    1'st gear not putting power to the ground

    just put the foot down for the first time this this season. does not seem to be putting the power down in first gear as much as last season. 2'ng gear still pulls hard and shift are firm and quick. the only change from last year is re-cored radiator and a manual boost controller. Boost still...
  10. jshot

    Do I have a problem?

    I am on this same basic "newbie" set-up. and as it has been discussed many times over on here, a big question is what is the next step?. Alky, bigger Turbo, or maybe a better intercooler.
  11. jshot

    Paint protection test

    I just applied griots 3 in 1 spray on ceramic coating. this is not an expensive coating that lasts 5 years but it will last probably 2 years on a sunday driver. for the price the performance is top. very easy to apply
  12. jshot

    Paint protection test

    check out this guy. tests over time. some tests are over 2 years. not a paid reviewer. test and visual results. simple as that https://www.youtube.com/c/ScottHD
  13. jshot

    Transmission cooler fitting, thread sealant ?

    i have this stuff already. says up to 300deg.
  14. jshot

    Transmission cooler fitting, thread sealant ?

    do i use any thread sealant on the 1/8 npt fittings for rans lines into rad ?
  15. jshot

    Rad support bushing, rubber

    rad support bushing. the small one goes on top correct? thanks
Top