Recent content by Jseverin

  1. J

    Re-locating to Northwest Florida

    That's not fun man, I'm still saving up to get the work done at premier otherwise I can admire the nice fresh paint on my new hot wheels car.
  2. J

    Re-locating to Northwest Florida

    Found this at Wal Mart in Navarre, I was pretty stoked!!!
  3. J

    Re-locating to Northwest Florida

    I have Mass at 11. Wanna meet up later in the afternoon? I stopped by premier, wanted to fill you in on what he said.
  4. J

    TPS Connector?

    So I can just replace the part that connects to the TPS. The entire assembly has 3 connectors and a long green wire that goes through the firewall on the drivers side. Want to avoid replacing the whole thing if possible.
  5. J

    TPS Connector?

    This looks more like the culprit http://www.jegs.com/i/Caspers-Electronics/182/102013/10002/-1
  6. J

    Re-locating to Northwest Florida

    Nice!!! I'll try to hit up the next one for sure.
  7. J

    Re-locating to Northwest Florida

    Not gonna make it guys. Flew all week and have to get all my homework done today. Hope to make it out again once my training slows down a bit.
  8. J

    TPS Connector?

    is the object in my attached photo the TPS connector? I ordered an AC Delco replacement one on rock auto and realized afterward the wire colors are different. I had a code 22 on my Scanmaster coupled with an erratic idle. I replaced the TPS itself set it to.42 and the car ran much better with...
  9. J

    Re-locating to Northwest Florida

    I'll try to make it out. Might just be for a little bit, I have a good amount of homework this weekend.
  10. J

    New TPS fluctuating

    i installed a new AC Delco TPS last week after my old one went bad. The car is running quite a bit better since it has been replaced. I set it at .40 at idle and 4.6 at WOT wither the engine off. With the engine on the TPS reads .42 at idle but momentarily jumps to .44 and back to .42. I don't...
  11. J

    Re-locating to Northwest Florida

    Had a great time, definitely looking forward to the next meet up!!
  12. J

    Re-locating to Northwest Florida

    Will you have the Buick today?
  13. J

    Troubleshooting Help

    Maybe I just missed the leak. it's gotta be vacuum b/c when I parked it at yesterday it was idling between 900-1000 rpms. I usually see 750-800. That coupled with high blm's (that return to the normal range while at highway speed)seems like a classic vacuum problem from what I've read on these...
  14. J

    Re-locating to Northwest Florida

    I'll try to make it over there. Car isn't running great but It will still be fun.
  15. J

    Troubleshooting Help

    Did the propane test and found no leaks, if I reset the ecm will it wipe out the tune I had done back in New Mexico?
Top