The test pipe is correct replacing the original cat (same as the GN) and the TTA originally got an adapter between the cat and exhaust (so from the rectangular part into the ball shaped part if you like) ... see photo ... that is needed
I got powder coated covers as well and they are from another FWD however those covers are all the same ... the TTA got the same covers and I got the list of what was reused by BOC building the engines and the valve covers where nothing special.
I have heard others had slight leak I think...
Well anything is possible I just based my comment on what I know and seen over the past 18 years and I also got a box full of OEM emblems and got a large quantity of photos of OEM emblems and none have 3M printed in the protective film and only Car motorsport do.
But I've been wrong before and...
Photo of what I'm looking for; any help or advice on what you guys used / use to replace the old seal/gasket would be much appreciated. Is there a Felpro replacement out there?
Ps. borrowed a photo from the internet of a low milage bottom half air box ... mine is pretty much all gone which is...
I'm looking to replace the gasket / seal on the original air cleaner setup; so the gasket/seal oo the bottom box.
Is there a Felpro or other brand OEM replacement out there I can pick up or what do you guys use / recommend ?
Any help / pointers much appreciated
Should say it's for a TTA so...
Yep those two identical pieces; no difference from the GTA but the cut out just infront of our intercooler scoop in the lower airdam otherwise 100% identical.
Very much appreciated, showed up this morning ... I'll have to see what I can piece together out of the 4 you sent me to get the right length/height required (0.398in).
Again thanks for sending these accross the pond very much appreciated; PM me if you want some $$$ for shipping etc.
I did mine a couple of years back ... posted on turbotransam.com about it and included some good useful links with pics.
Well worth the time and effort in the end.
Still trying to get hold of the spacer needed .... anyone happen to have one? I believe the same spacer was used on lots of different Delco alternators so if you have a scrap one sitting around and don't mind taking it apart I would appreciate it :-)