Vacuum brakes are fine for the street and in an occasional emergency stop. Looks like you're on the right track. Make sure you don't have any vacuum leaks elsewhere so you get enough pressure. Might be time to upgrade your old hoses to silicone if you haven't already.
I have only ever had...
I always buy extra/bulk so i don't end up running short. I was curious if anyone has any leftover black carpet material that would match any of the black trunk carpet kits to wrap around the bottom and sides of my current sub box project? I think the trunk carpet kit manufacturer is R.E.M. or...
The SC&C Brace does clear a precision FMIC but IIRC it doesn't clear a ridetech muscle bar. i had to go with GNS front braces and i was equally as happy
Does anyone have one or know who sells them before i have my buddy make one? I'm using the test pipe dump end with a turn down and would like to cap the 4 bolt end until i get sick of the noise. I measured 4-3/8" center to center on the top bolts and 2-3/4 center to center on the side bolts...
I found out like you and didn't even know about it. I have same setup pretty much with wilwood front and rear conversion. I went with the wilwood master cylinder and added their proportioning valve right under it.
The brass block mounted to the frame screws everything up but you have two...
Does anyone know what the sticky rubber pieces are on our factory gas tanks? I bought a spectra replacement and was debating on removing them from the old tank and putting them on the new one. If Im confusing anyone, they are the rectangular molded rubber pieces stuck on the bottom and back of...
yes and redrill out the two existing bolt holes. then line up the kit and mark the other two holes and drill them. as far as the whole parking brake setup, the link above is what i bought what theyack mentioned above...