Recent content by gthmcty1

  1. G

    OFFICIAL: wheel/tire picture thread... show em off!

    Any specs on the backspacing, and adapters needed?
  2. G

    1985 Buick Regal in SoCal Moreno Valley $1000 OBO

    1985 3.8L with 106k on the clock nothing special power windows and tilt column, body is pretty straight needs front and rear fillers original 14" rims with wire hubcaps, would make a mean pro-touring regal I want to get back into the older cars (1975 and down) the motor has the number 6 cylinder...
  3. G

    CEL code 41?

    Thanks for the tips guys
  4. G

    CEL code 41?

    What is this I found this inside the kick panel with the ECM...Its looks like a MAP sensor?
  5. G

    CEL code 41?

    ok thanks Charlie, looks like that engine swap may have been sped up.....
  6. G

    CEL code 41?

    Can these be replaced? If so from where, and autozone?
  7. G

    CEL code 41?

    Sorry it's an 85 NO, where might I found those two items?
  8. G

    CEL code 41?

    It says it is a bad "mem-cal"? Not that familiar so I am hoping someone can point me in the correct direction to troubleshoot this code? I cleared it twice and then disconnected the negative batt terminal for 1 minute and it came back twice. Any idea what triggers this and if so what can I...
  9. G

    Knock Sensor

    No not at all THAT is the stumper???? The only code it threw was a VSS code which I knew why cause I had the speedo unhooked I disconnected the negative terminal on the battery for 30 seconds to erase the codes and it didn't throw any other codes........since then.
  10. G

    Knock Sensor

    Well checked the carb and it was within specs nothing stuck, changed the wires and plugs still running like crap.....any other suggestions?
  11. G

    Knock Sensor

    LOL Charlie at this point I will try anything, lol this thing is running so rich right now (gotta love the 2 barrels). Thanks Charlie will report back
  12. G

    85 v6 (na)

    Exhaust note changed it is very evident that it is missing, I will check vacuum today!
  13. G

    Knock Sensor

    Timing is dead on not issues there ECM is functioning correctly, the ECM turns off and on as described. DOES the knock sensor control the advance of the distributor since it does not have a vacuum advance?
  14. G

    Knock Sensor

    Guys I think I have a bad knock sensor but it is not throwing any codes but my car is pinging like crazy, ( I originally posted this in the ENGINE section) I cleaned the EGR valve but it still pings, this is a NA V6 doesn't the knock sensor retard the timing since our cars are not equipped with...
Top