Recent content by gczarny

  1. G

    XFI 2.05 very long initial crank , any ideas ?

    I just wanted to let everybody know that my long cranking problem is fixed for sure , what it turned out to be was wiring/connection problem somewhere , I decided to go through all grounds and connectors I could think of ,unplug - spray contact cleaner - plug back in couple of times -you know...
  2. G

    XFI 2.05 very long initial crank , any ideas ?

    yes ,both XFI and XIM crank and cam led are blinking right away but no go for 10 sec .I had spark tester on ign wire and it had spark ,just do not know if in synch . Greg
  3. G

    XFI 2.05 very long initial crank , any ideas ?

    That's only true for stock ignition module ,with XIM you have full control of start up timing , I tried IAC start position from 255 to 125 ,made no diference , I have my second FP set up to come on by TPS at 60% ,I tried to pressurise system with second fuel pump few times and this also made...
  4. G

    XFI 2.05 very long initial crank , any ideas ?

    XFI 2.051 build date 05/19/14 XFI Firmware XFI2_B9 XIM Firmware XIM_20E
  5. G

    XFI 2.05 very long initial crank , any ideas ?

    That's how I start mine too, fuel prime is set tp 5 sec so I wait till FP shuts off then crank , I will be trying few things over the weekend ,I also smell some gas while driving and I can NOT figure out where it is comming from under the hood , one time I was seeing wet around FP regulator...
  6. G

    XFI 2.05 very long initial crank , any ideas ?

    yes , dead on Yes , dead on . Talked to Cal the other day ,he made a point that if the engine stops in "bad spot " it make take a while for XFI to resynch cam/ crank pulses if batt volts are low /crank slow , that's not it ,it cranks fast enough to resynch it in less then 10 seconds , not to...
  7. G

    XFI 2.05 very long initial crank , any ideas ?

    I did test when I turn key on ,wait 1 min for wide band to heat up and read properly and then crank and watch cranking AFR , tried from 7 to 12 by adjusting cranking fuel ,same thing and it does not matter if this is cold start or engine is at 170 F ,if it sits for 5 minutes it will have long...
  8. G

    XFI 2.05 very long initial crank , any ideas ?

    I am heaving really long initial cranking problem 10-15 seconds before it fires up most of the time ,at times it will fire up right away but most of the time it takes that long to get it started ,after that will start right up till it sits for a while and then same long crank problem . My...
  9. G

    1987' GN , new engine , will trade !

    Dyno pull video , now you can hear how my V6 sounds under load . , so far I had very nice offer trades but mostly build cars ,I am really looking for mostly stock car to drive around and everyday to work here in Florida :cool:
  10. G

    1987' GN , new engine , will trade !

    Price drop on my ride , 29K or best offer and still will trade !
  11. G

    Few extra parts for sale ,2 sets of cometics

    valve covers and timing chain set sold !
  12. G

    Few extra parts for sale ,2 sets of cometics

    got paid , I will ship it Monday .thanks
  13. G

    Few extra parts for sale ,2 sets of cometics

    I forgot I also have set of GN1 valve covers with hardware ,1.5 inch breathers adaptors included , $120 shipped in 48 lower states .
  14. G

    Few extra parts for sale ,2 sets of cometics

    No module ,just coil pack and wires
Top