Recent content by fc227

Never mind found it , one of the wires on the stalk as a intermitting short to grd. Wiggle the wire shorts wiggle it again opens . AGH !!!!

Hi everyone, My cruise control was working, Now blowing the 5 amp fuse. Here is what I did so far car running , but not moving. move the slide switch to on , acell , and back to off. Does not pop the fuse . But when I drive and try to activate , it pops the fuse Disconnected the servo ...

Yea, that is it . haven't been able to locate one. Thank you

Agreed. One more issue I found . Racetronics fuel pump hot wire kit , the connector failed . Anyone know what the proper name for the style connector is ?

I'm going to call Jack Cotton next week if he is open and order a replacement coil and module and another maf (The back up I had is bad). I also had to kick some mice out from under the back seat. that's another mess I have to take care off . My own fault for not driving it more.

Thank you everyone, took it out ran like poo . got it back home. started pulling plug wires ( I am not a fan of this , it could cause the secondary to internal short . ). Turns out 3&6 where not firing , that coil pack on 3&6 was hot . Turns out the Ignition module went sour . I had a...

I agree , But i let it run for 1/2 hour . Always let it get up to temp.

correction, INT is also going up to 140 , O2 is reading low ~ 300mv (Th e O2 could be the problem) but it is do this in open loop so..... I did not pull a plug but the exhaust is black (Not blowing black smoke, but the pipe has a black sooty deposit). Has far as I can tell I do not have a...

HI everyone, I hope this post finds everyone well. I am having a interesting problem. The car has been sitting for a while but started every week. Also we had heavy rain yesterday. Don't know if things got wet. but anyhow. I am running several chips on a thumb wheel . Bob Baileys...

Greeting all , It's been a while. I bought a Willem eprom PCB5.0E programmer but can not find the software to run it . I went to one site and got a nasty virus that made me have to wipe the hard drive. So if anyone has and or knows where I can download a "clean" version it would be...

Rusting out , Plus I miss spelled Donor . Sorry everyone :( T-top and the pillars are rusting out.

HI Everyone, Thing about do a body swap on the GN , Looking around for a downer car . Question , what does one do about the vin number . I can imagine that the feds would not be happy about swapping out the vin plate from the old body to the new one? Technically its still the same car, but...

Yes, it was stripped. 8MM I got a longer bolt and good to go for now. Thank guys

Is there such a thing a 9MM bolt , It not a 8mm and 10 IS too big.

HI Everyone, Does anyone happen to know what size bolt is used on the drivers side mounting bolt for a Stretch inter-cooler, MPE racing . I believe I got this though Jack Cotton. The drivers side bolt is missing and if some one knows what size bolt that is would save me some trail...